Table of Contents
Advertisement
f
NOTE: When the key switch is turned ON, the maintenance
notification (4) for the item whose maintenance interval has
expired displays for ten seconds. Press Return switch (5) or
turn the pilot control shut-off lever to UNLOCK position while
the rear view camera is enable to delete the notification.
7. The basic screen will be displayed on the monitor. Check
that the preheat indicator (6) is OFF at this time.
8. Turn key switch (2) to START position to rotate the
starter. The engine will start.
IMPORTANT: Never operate the starter for more than 10
seconds at a time. If engine fails to start, return key
switch to OFF. Wait for more than 30 seconds, then
try again. Failure to do so may cause damage to the
starter and/or discharging the batteries.
9. Release key switch (2) immediately after the engine has
started. Key switch (2) will automatically return to ON
position.
f
NOTE: Because of the engine speed control function, the
engine speed will be kept to slow idle speed for about 3 to
6 seconds right after the engine starts. When the coolant
temperature or hydraulic oil temperature is low, the time will
be longer. The engine speed will be kept to slow idle speed
even if the engine control dial (3) is not set in the slow idle
position.
f
NOTE: The warm-up system automatically operates
after keeping slow idle speed, and the engine speed will
temporarily increase even if the engine control dial (3) is set in
the slow idle position.
d
WARNING: Do not attempt to operate the machine for
six seconds after starting the engine. The engine speed
may change after the slow idle period and operation
speed of work device may suddenly increase, which
may cause serious accident.
f
NOTE: White smoke may occur for several minutes after the
engine start, this is not a malfunction.
OPERATING THE ENGINE
3-4
4
MDAA-01-213EN
5
MDCD-01-026
6
MDAA-01-042
Basic Screen
Advertisement
Table of Contents
