Table of Contents
Advertisement
Connecting the ProLine element
Connect the ProLine element/ele-
ments to the electricity supply and to
the gas supply (see "Installation –
Electrical connection" and "Gas con-
nection").
Checking operation
After installation, ignite all burners to
check that they are operating cor-
rectly:
- The flame must not go out on the
lowest setting, or when the control is
turned quickly from the highest to the
lowest setting.
- On the highest setting, the flame
must have a distinctive and visible
core.
Removing a ProLine element
If the ProLine element is accessible
from below, push it upwards to re-
move it. Push the back of the appli-
ance out first.
If the ProLine element is not access-
ible from below, take hold of the ap-
pliance with both hands at the back,
pull it forwards, then lift it up and out.
Installation
51
Advertisement
Table of Contents
