Tonze AW-6660 Quick Installation Manual

 AW-6660: 802.11a+g WDS AP Quickly Installation Guide

1. Hardware Installation

Rear Panel: The rear panel features 1 Ethernet port, 2 RPSMA Female Connectors, Reset button and
Power port. Refer to the following table for the meaning of each feature.
ANT2 Reset
Reset: The Reset button can restore device to factory default settings by press this button for

approx. 10 seconds during device power on status.
 RPSMA Female Connectors: There are two RPSMA Female connectors, Ant 1 is for 802.11a and
Ant 2 is for 802.11b/g.
 Power: The Power port is where you will connect the power adapter.

2. AP Default Settings

User:

Password: admin.

IP Address: 192.168.1.250.

 Subnet Mask: 255.255.255.0
RF ESSID: A Band: wlan-a, G Mode: wlan-g

 Channel: A Band: Auto, G Band: 6
Mode: G Band: Mixed.


3. Hardware Installation for Connection to Your local network

 Power off your network devices.
Locate an optimum location for the AP. The best place for the AP is usually at the center of your

wireless network, with line of sight to all of your wireless devices.
Adjust the antennas. Normally, the higher location of your AP will get better the performance.

Connect your network PCs or Ethernet devices to the AP's LAN ports using standard Ethernet

network cabling.
Connect the AC power adapter to the AP's Power port. Then connect the other end to an

electrical outlet. Only use the power adapter supplied with the AP. Use of a different adapter
may cause product damage.
 The Hardware installation is completed; please refer to the following content for AP
configuration.

4. How to Configuring the Dual Band AP

START UP & LOGIN
In order to configure the Wireless 11ag AP, you must use web browser and manually input
http://192.168.1.250 into the Address box and press Enter. The Main Page will appear.
Tonze Technology Cooperation
RJ45
www.tonze.com.tw
5V/2.5A ANT 1