Cleaning And Care; Cleaning The Air Filter - Silvercrest 9000 BTU Operation And Safety Notes

Problem
The product
is very loud.
Error code E0 The room temperature
Error code E2 The water tank is full.

Cleaning and care

RISK OF ELECTRIC SHOCK!
Improper handling of the product
may result in electric shock.
Always switch the product off
and unplug the mains plug
from the socket before cleaning
the product.
ATTENTION! RISK OF
SHORT CIRCUIT! Water or
other liquids inside the housing
may cause a short circuit.
Never immerse the product in
water or other liquids.
Do not allow water or other
liquids to enter the housing.
ATTENTION! RISK OF
DAMAGE! Improper use of the
product may result in damage to
the product.
Do not use aggressive cleaning
agents, brushes with metal or
nylon bristles, or sharp or metal
44 GB/IE
Possible cause
The product is standing on
uneven ground.
sensor is defective.
10
Solution
Place the product on as
level and flat a surface
as possible.
Contact customer service.
Empty the water tank.
objects such as knifes, hard spat-
ulas, etc. These can damage the
surfaces.
Clean the housing and the remote
control with a soft, dry cloth.
11

Cleaning the air filter

Clean the air filter
weeks or when it is visibly dirty.
Unplug the mains plug
cleaning.
Drain the water tank completely
(see chapter "Draining the water
tank").
Wipe the product with a slightly
damp cloth. Then allow all parts
to dry completely.
Remove the air filter
housing (see fig. J).
Clean it with lukewarm water
(max. 40 °C) and some neutral
detergent and let it air dry com-
pletely (without direct sunlight).
Put the air filter
housing.
every 2
6
before
10
from the
6
back in the
6