Welding Condition For The Ceramic Oscillator; (Cstc4.30Mg-Tc); Error Message - Casio CFX-9800G Service Manual & Parts List

• Be sure to always keep written copies of all important data in case
you accidently delete it using the RESET operation.
• If the calculator stops operating correctly for some reason, use a
thin, pointed object to press the RESET button on the back of the
calculator. This should make the RESET confirmation screen
appear on the display. Perform the procedure described above to
complete the RESET operation.
• If the RESET confirmation screen does not appear when you press
the RESET button, keep pressing the button until it does.
6. WELDING CONDITION FOR THE CERAMIC OSCILLATOR (CSTC4.30MG-TC)
Because the heat-resisting test for welding the ceramic oscillator (CSTC4.30MG-TC) was adminis-
tered by factory under the condition that weld temperature was 240 ± 5 °C and welding time was 3 ±
1 seconds after the preheating of 150 ± 30 °C temperature and 60 seconds time, it is recommended
that you should give first priority to take the welding condition, 150 ± 30 °C and 60 seconds for
preheating, and 230 ± 5 °C and less 20 seconds for welding, if you have to weld the ceramic oscilla-
tor (CSTC4.30MG-TC).

7. ERROR MESSAGE

Message
Syn ERROR 1 Calculation formula contains an error.
2 Formula in a program contains an
error.
1 Calculation result exceeds calculation
Ma ERROR
range.
2 Calculation is performed outside the
input range of a function.
3 Illogical operation (division by zero,
etc.)
4 Poor precision in Σ calculation results.
5 Poor precision in differential calcula-
tion results.
6 Poor precision in integration calcula-
tion results.
7 Cannot find results of equation calcula-
tions.
1 No corresponding Lbl n for Goto n.
Go ERROR
2 No program stored in program area
Prog n.
Meaning
— 10 —
RESET button
Countermeasure
1 Use or to display the point
where the error was generated and
correct it.
2 Use
or to display the point
where the error was generated and
then correct the program.
1234
Check the input numeric value and
correct it.
When using memories, check that the
numeric values stored in memories are
correct.
5 Try using a smaller value for ∆ x (x
increment/decrement).
6 Try using a larger value for n (number
of partitions).
7 Check the coefficients of the equation.
1 Correctly input a Lbl n to correspond to
the Goto n, or delete the Goto n if not
required.
2 Store a program in program area Prog
n, or delete the Prog n if not required.