Installing The Dialog Oven - Miele DO 7860 Operating And Installation Instructions

Installation

Installing the Dialog oven

For safety reasons, the Dialog oven
must only be used after it has been
built in.
The Dialog oven requires a sufficient
supply of cool air for efficient
operation. The required supply of
cool air must not be excessively
heated by other heat sources (e.g.
solid fuel stoves).
The following must be observed
when installing the appliance:
Do not fit a back panel in the housing
unit.
Ensure that the interim shelf that the
Dialog oven sits on does not touch
the wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
 Before starting installation work,
ensure that there is no power to the
socket.
 Connect the Dialog oven to the
electrical supply.
Lifting the Dialog oven by the door
handle could cause damage to the
door.
Use the handle cut-outs on the side
of the casing to lift the appliance.
 Push the Dialog oven into the housing
unit and align it.
 Open the door.
112
 Pull the water intake pipe forwards
(located below the control panel on
the left).
 Secure the Dialog oven to the side
walls of the housing unit using the
screws supplied.