Table of Contents
Advertisement
R
A F
EPLACING
Hard Disk Safety Information
W
ARNING: Installation and removal of the Hard Disk must be
carried out by qualified personnel only. This Hard Disk is not
hot-swappable. Always make sure the Network Storage Server is
powered down and disconnected from the mains before
removing and installing the Hard Disk. For full safety instructions,
see
page
36.
AVERTISSEMENT: L'installation et la dépose du disque dur sont
à effectuer uniquement par du personnel compétent. Ce disque
dur n'est pas hot swappable (ne peut pas se brancher/débrancher
à chaud). Vérifiez toujours que le serveur de programmes de
mémoire sur réseau est mis hors tension et débranché de la prise
secteur avant de retirer et d'installer le disque dur. Pour des
explications complètes sur la sécurité, reportez-vous
WARNHINWEIS: Der Ein- und Ausbau der Festplatte ist nur von
ausgebildetem Personal auszuführen. Diese Festplatte darf nicht
während des Betriebs ausgetauscht werden. Fahren Sie den
Network Storage Server herunter und trennen Sie ihn von der
Stromversorgung, bevor Sie die Festplatte entfernen
beziehungsweise installieren. Weitere Sicherheitsanweisungen
finden Sie auf Seite 37.
CAUTION: A 20 GB Hard Disk will only work with the
OfficeConnect Network Storage Server 20 (3C19500). A 40 GB
Hard Disk will only work with the OfficeConnect Network
Storage Server 40 (3C19501). The Hard Disks are not
interchangeable.
If 3Com Technical Support cannot resolve your Hard Disk
problem, you may have to purchase a replacement Hard Disk.
Replacement Hard Disks are only available from 3Com.
H
AULTY
ARD
page
D
ISK
About the Hard Disk
The Network Storage Server has a removable Hard Disk that
allows you to replace it in the unlikely event it should fail.
3Com recommends that you regularly backup the information on
your Network Storage Server. There are two main areas to
consider: the configuration settings of the Network Storage
Server and the actual Hard Disk data saved by the Users and
Groups.
Backing Up the Configuration Settings
You can backup the configuration settings in two ways. You can
make a backup through the Commands section in the
Administration System. Alternatively, you can backup the
36.
configuration settings through the Network Storage Server's
Failsafe Mode. See
Failsafe Mode.
Backing Up the Data
You can backup the Users data by running a backup application
such as Microsoft's Windows Backup which is normally provided
with Windows 95, Windows 98 and Windows NT 4.0 Operating
Systems.
If you have not backed up your Network Storage Server data and
the Hard Disk fails, you might try a specific data recovery agency
to retrieve the data.
If you have problems with the Hard Disk that cannot be resolved
in the
"Troubleshooting"
Support. See
23
page 21
for details on how to access the
section on
page
30, contact Technical
page 40
for contact details.
Advertisement
Table of Contents
