Tool Menu, Functions - Husqvarna Automower 420 Technical Manual

2.6 Tool menu, functions

Via the Tools menu, you can access data about the
mower's function, test functions and special settings.
• Info
Information about current status of
software, sensors, battery, loop signal, etc.
• History, total
Key data, which gives an overview of a
mower's age and function.
•
History, trip
Resettable key data.
•
Test
Possibility to test the mower's different
components and functions.
• Special settings
Turn off loop detection, demo mode,
calibration of the tilt sensor and guide wire,
installation lock.
• Calibrate
Calibration of guide, tilt sensor and cutting
height adjustment
2.6.1 Info
The values displayed in this sub-menu show the cur-
rent status of the mower's different subsystems, e.g.
software, battery, motors and sensors. The menu
can be used in connection with e.g. troubleshooting.
The General, Battery, Loop, Sensors and
Automower Connect functions show the same
information as in the Quick Info menu above.
The Info - Motors - Wheel menu shows for the right
and left wheel motors:
Speed: The wheel motor speed in cm/s.
•
• Current: Nominal power consumption,
measured in mA.
• Power: The actual power the wheel motors
are currently being operated with. This
varies depending on for instance the
inclination the mower is operating on.
The Info - Motors - Cutting menu shows:
• Speed: The blade motor speed, nominal
speed is 2,300 rpm.
• Current: Nominal power consumption,
measured in mA.
English - 28
2. SPECIAL MENU FUNCTIONS
Info
History, total
History, trip
Test
Special settings
Calibrate
General
Battery
Loop
Sensors
Automower Connect
Motors
GPS-navigation