Advertisement
OEM Responsibilities to comply with FCC and Industry Canada Regulations
The module has been certified for integration into products only by OEM integrators under the
following condition:
-The antenna(s) must be installed such that a minimum separation distance of at least 20 cm is
maintained between the radiator (antenna) and all persons at all times.
-The transmitter module must not be co-located or operating in conjunction with any other antenna
or transmitter except in accordance with FCC multi-transmitter product procedures.
As long as the two condition above is met, further transmitter testing will not be required. However,
the OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC
peripheral requirements, etc.).
End Product Labeling
The module is labeled with its own FCC ID and IC Certification Number. If the FCC ID and IC
Certification Number are not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a label referring to the
enclosed module. In that case, the final end product must be labeled in a visible area with the
following:
"Contains FCC ID: BEJ-EBR81777301
"Contains IC: 2703N-EBR81777301"
Étiquetagedu produitfinal (IC)
Le module BT111 est étiqueté avec sa proper identification FCC et son proper numéro de
certification IC. Si l'identification FCC et le numéro de certification IC ne sont pas visibles lorsque
le module est installé à l'intérieur d'un autre dispositif, la partie externe du dispositif dans lequel
le module est installé devra également presenter une etiquette faisant reference au module inclus.
Dans ce cas, le produit final devra être étiqueté sur une zone visible avec les informations
suivantes:
« Contient module émetteur identification FCC ID : BEJ-EBR81777301
« Contient module émetteur IC : 2703N-EBR81777301"
Advertisement
