Kenwood KDC-BT6544U Instruction Manual page 37

• CD READ
Sets the method for reading CD.
When unable to play special format CD, set this
function to "2" to force playing. Note that some
music CD may be unplayable even when set to "2".
In addition, audio files cannot be played when set
to "2". Normally, keep this set to "1".
1 : Automatically distinguishes between audio file
disc and music CD when playing disc.
2 : Forces playing as music CD.
• DISPLAY
If this unit is not operated at least 5 seconds with
"OFF" selected, the display turns off. During a setup
mode, the display will not turn off even if 5 seconds
lapse.
• DTA (Digital Time Alignment)
Make fine adjustment of the delay time of the
speaker output specified at <Cabin selection>
(page 23) to have a more suitable environment for
your vehicle.
The settings of the delay time are automatically
identified and compensated by specifying the
distances of each speaker from the center of the
vehicle interior.
1 Set the front and rear positions and the height
of the reference point to the position of the ears
of the person sitting in the front seat, and set
the right and left positions to the center of the
vehicle interior.
2 Measure the distances from the reference point
to the speakers.
3 Calculate the distance difference in accordance
with the farthest speaker.
FRONT
REAR
150cm
+100cm
FRONT
50cm
80cm
REAR
+70cm
+0cm
SUB-W
• DVC STATUS (Displaying the Bluetooth device
Status)
You can display the connection status, signal
strength, and battery level.
: Battery level of cell-phone.
Full
: Signal strength of cell-phone.
Maximum
⁄
• Icons are not displayed if information cannot be
obtained from the cell-phone.
• Since the number of steps of the control unit is different
from that of the cell-phone, the statuses displayed on
the control unit may discord from those displayed on
the cell-phone.
• HIGHWAY-SND (Highway sound)
Increases the volume of faintest sound being lost
by road noises to make the sound more audible.
Additionally, it accentuates bass sound being
lost by road noises to make the bass sound more
dynamic.
• MIC GAIN
Adjusts the sensitivity of the built-in microphone
for a telephone call. Adjust the voice of caller.
Setting to "+" increases the voice volume.
• NEWS (News Bulletin with Timeout Setting)
Automatically receives news bulletin when it
starts. Set the time during which interrupt is to be
disabled after start of another news bulletin.
Changing "NEWS 00M" to "NEWS 90M" turns this
function ON.
If news bulletin starts when this function is ON,
"TRAFFIC" is displayed and news is received. If "20M"
is has been set, reception of another news bulletin
will not start for 20 minutes.
The news bulletin volume is the same level that
was set for Traffic Information.
• NR LEVEL
Reduces the noises generated by surrounding
environment without changing the built-in
microphone volume. Adjust the voice of caller
when it is not clear. Setting to "+" increases the
noise reduction.
• POWER OFF (Power OFF Timer)
Setting the timer to turn this unit's power OFF
automatically when Standby mode continues.
Using this setting can save the vehicle's battery
power.
– – –: Power OFF Timer function is OFF.
20min: Turns the power OFF after 20 minutes.
(Factory setting)
40min: Turns the power OFF after 40 minutes.
60min: Turns the power OFF after 60 minutes.
Nearly dead
Minimum
37
|
English