Uploading Data To The Keypad; Downloading Data From The Keypad; Restoring Default Settings; Recommended Initialisation - GE AF-600 FP Series Design And Installation Manual

User Interface
WARNING
UNINTENDED START!
When the frequency converter is connected to AC mains,
the motor may start at any time. The frequency converter,
motor, and any driven equipment must be in operational
readiness. Failure to be in operational readiness when the
frequency converter is connected to AC mains could result
in death, serious injury, or equipment or property damage.

4.2.1 Uploading Data to the Keypad

1. Press [Off] to stop the motor before uploading or
downloading data.
2. Go to K-50 Keypad Copy.
3. Press [OK].
4. Select All to keypad.
5. Press [OK]. A progress bar shows the uploading
process.
6. Press [Hand] or [Auto] to return to normal
operation.

4.2.2 Downloading Data from the Keypad

1. Press [Off] to stop the motor before uploading or
downloading data.
2. Go to K-50 Keypad Copy.
3. Press [OK].
4. Select All from keypad.
5. Press [OK]. A progress bar shows the
downloading process.
6. Press [Hand] or [Auto] to return to normal
operation.

4.3 Restoring Default Settings

CAUTION
Initialisation restores the unit to factory default settings.
Any programming, motor data, localization, and
monitoring records will be lost. Uploading data to the
keypad provides a backup before initialisation.
Restoring the frequency converter parameter settings back
to default values is done by initialisation of the frequency
converter. Initialisation can be carried out through
H-03 Restore Factory Settings or manually.
•
Initialisation using H-03 Restore Factory Settings
does not change frequency converter data such
as operating hours, serial communication
TM
AF-600 FP Design and Installation Guide
•
•

4.3.1 Recommended Initialisation

1.
2.
3.
4.
5.
6.
7.
Default parameter settings are restored during start up.
This may take slightly longer than normal.
8.
9.

4.3.2 Manual Initialisation

1.
2.
Factory default parameter settings are restored during start
up. This may take slightly longer than normal.
Manual initialisation does not reset the following frequency
converter information
•
•
•
•
DET-768b
selections, personal menu settings, fault log,
alarm log, and other monitoring functions
Using H-03 Restore Factory Settings is generally
recommended
Manual initialisation erases all motor,
programming, localization, and monitoring data
and restores factory default settings
Press [Main Menu] twice to access parameters.
Scroll to H-03 Restore Factory Settings.
Press [OK].
Scroll to [2] Restore Factory Settings.
Press [OK].
Remove power to the unit and wait for the
display to turn off.
Apply power to the unit.
Alarm 80 is displayed.
Press [Reset] to return to operation mode.
Remove power to the unit and wait for the
display to turn off.
Press and hold [Status], [Main Menu], and [OK] at
the same time and apply power to the unit.
ID-00 Operating hours
ID-03 Power Up's
ID-04 Over Temp's
ID-05 Over Volt's
4 4
33