Kenwood KVT-729DVD Instruction Manual: Help? Troubleshooting

Monitor with dvd receiver.
Hide thumbs
Help?
Troubleshooting
Some functions of this unit may be disabled by
some settings made on this unit.
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
Subwoofer is not set to On.
(page 66)
The Dual zone function is enabled.
Control> (page 88)
!
Cannot set up the subwoofer phase.
Subwoofer is not set to On.
(page 66)
Low pass filter is set to Through.
Network Setup> (page 67)
!
• Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear
speakers.
The Dual zone function is disabled.
Control> (page 88)
!
Cannot play audio files.
"CD Read" of <System Setup> (page 71) is set
to "2".
!
Cannot Folder select.
The Scan play or Random play function is
enabled.
!
Cannot perform Repeat play.
The PBC function is enabled.
!
• Cannot set up the equalizer.
• Cannot set up the crossover network.
The Dual zone function is enabled.
Control> (page 88)
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
<Audio Setup>
<Zone
Tuner source
<Audio Setup>
<Crossover
Disc source
<Zone
Audio file source
<Zone
?
The Touch Sensor Tone doesn't sound.
The preout jack is being used.
The Touch Sensor Tone can't be output from
the preout jack.
?
Radio reception is poor.
The car antenna is not extended.
Pull the antenna out all the way.
The antenna control wire is not connected.
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
?
The specified disc does not play, but another
one plays instead.
The specified CD is quite dirty.
Clean the CD.
The disc is loaded in a different slot from that
specified.
Eject the disc magazine and check the
number for the specified disc.
The disc is severely scratched.
Try another disc instead.
?
The sound skips when an Audio file is being
played.
The media is scratched or dirty.
Clean the media, referring to the CD
cleaning of the section on <Handling CDs>
(page 8).
The recording condition is bad.
Record the media again or use another
media.
English
95

Advertising

   Also See for Kenwood KVT-729DVD

   Related Manuals for Kenwood KVT-729DVD

Comments to this Manuals

Symbols: 0
Latest comments:
  • James Swinnie Nov 24, 2015 03:25:
    I have a Kvt-719dvd player had it along time and need a password to make it start playing again.