Table of Contents
Advertisement
Using the menus (Continued)
• [Interval]
You can set the display interval of time (in seconds or minutes) for slide shows to be
played automatically.
Note
It may take time to display slide show with some files.
• [Display effect]
When playing a slide show, the projector can give various display effects or transitions
to each slide being displayed.
The transitions available are listed below:
None
•
Displays each slide with no display effects.
Wipe
•
Displays the next slide with a gradual upward (Wipe ↑), downward (Wipe ↓), to the left
(Wipe ←), or to the right (Wipe →), over the current slide.
Dissolve
•
Displays the next slide gradually in a certain fixed block pattern over the current slide.
Cover
•
Displays the next slide as sliding upward (Cover ↑), downward (Cover ↓), to the left
(Cover ←), or to the right (Cover →), over the current slide.
• [Play icon]
The slideshow icon can be displayed.
Standard
•
The projector handles the slideshow icon as follows depending on the "On/Off" setting
of Icon on the projector's menu.
Icon On: The projector displays the icon upon the start of playing a slide show and
turns it off after a few seconds.
Icon Off: The projector does not display the icon.
Continuous
•
The projector keeps the icon displayed during the slide show.
• [Thumbnail display]
Select the form of a thumbnail list.
All: Displays a thumbnail preview of JPEG files, and if any JPEG files exist in the
folder displays the leading thumbnail image.
File: Displays only a thumbnail image of JPEG files. The thumbnail image of the JPEG
files in the folder is not displayed.
Off: Displays an icon without displaying thumbnail preview.
• [Unplug device]
Run when unplugging a USB memory, a USB memory card reader/writer or a digital
camera and the like.
44
Displaying Information (Status display)
This displays information about the input signal, lamp use time, etc.
Item
Description
Input
Input source name
[Note 1]
Mode name
RGB input mode
Resolution
Resolution (in dots)
Frequency
Sync frequency
[Note ]
Sync
Sync signal polarity
Signal format
Y/P
/P
signal format
B
R
Video mode
Color method of video signal
[Note ]
Lamp time
Time of lamp use
Lamp reset count
The count for lamp replacement
Total time
The total time that this projector
is used.
[Note 4]
Version
Firmware version
Notes
1:
The mode of supported RGB signals
:
Sync signal polarity shown as P (positive) or N (negative) for [H/V].
:
Displays [Lamp time] as an estimated measure of when the lamp should be replaced.
(Cannot be used as a counter of guaranteed lamp time.) When the displayed time
approaches ,000 hours, consult with a dealer about getting replacement lamp
TLPLW1 (sold separately).
4:
[Version] shows the version of the projector's internal control program. This version will
be requested for customer service purposes.
Note
•
The displayed information will not be refreshed if the status changes. To refresh the
information, dismiss the display, then display it again.
"Yes": displayed, "No": not displayed
Computer Y/P
/P
Video
S-video
B
R
Yes
Yes
Yes
Yes
Yes
No
No
No
Yes
No
No
No
Yes
No
No
No
Yes
No
No
No
No
Yes
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
p.66
is shown.
45
USB
memory
Yes
No
No
No
No
No
No
Yes
Yes
Yes
Yes
Advertisement
Table of Contents
