Table of Contents
Advertisement
Using the menus (Continued)
The Default setting menu
This menu shows placement status and other settings.
Default setting 1 menu
Item
Auto keystone Always corrects keystone distortion automatically.
No signal
Sets the time to wait for the power to be turned off after the last operation is
power off
made with no input signal.
Auto input
Sets whether the input with signals is only selected or not.
search
Beep
Beeps when operation is made.
Power on
Sets whether to turn on the power when the ON/STANDBY button is pressed
(Manual), or when the power cord is plugged in (Auto).
Lamp power
Sets the lamp power.
Detailed description
[Auto input search]
[On]: Automatically searches the signals that can
be projected, and switches input from the
connected device that outputs the video signals
each time the INPUT button is pressed. Input
from a connected device that outputs no video
signals is skipped.
[Off]: Displays the Input select menu.
Toggle with
buttons and press
(The input without signals can be also selected.)
Note
•
In normal operation, set [Auto input search] to [On].
Set to [Off] when you want to select the input source from Input select menu, or if
the image does not appear properly.
[Power on]
If [Power on] is set to [Auto] and there is a power outage, the projector will come on
once power is restored.
[Lamp power]
When [Lamp power] is set to [Low], the screen becomes a little darker, but the cooling
fan noise gets quieter.
Description
On
Off (not turned off)
30 min.
On
On
Manual
Low
Standard
Input select menu
Input select
Computer 1
Y/P
/P
1
B
R
Computer 2
Y/P
/P
2
B
R
Video
S-video
USB memory
button.
/
shows whether signal is
input or not.
40
Default setting 2 menu
Item
Projection
mode
Fan mode
Off
Remote control When projectors are used and controlled by the remote control respectively,
Off
Off
Key lock
Auto
Closed Caption Closed Caption settings.
Reset all
Password
Detailed description
[Fan mode]
Setting [Fan mode] to [High] increases the cooling fan speed. (The cooling fan noise
increases.) Set this option to use the projector at high altitude (over 1,500 meters
above sea level).
•
Do not set Fan mode to [High] when using the projector at a lower altitude.
[Remote control]
Sets a remote control code from types. You can set each code respectively for up to
projectors. The factory setting is [1].
To switch codes, set the same code for the projector and the remote control.
A remote control code is applied after the setting is done.
•
You cannot operate the remote control if the codes of the projector and the remote
control do not match.
Remote control code setting for remote control
Set the same remote control code switch as the projector.
Description
Sets projection mode in accordance with Placement Style.
(Standard)
(Rear)
Sets the cooling fan speed.
this menu sets the code for the projector and the remote control.
[
or
: Enter setting]
[
: Select from 1, 2
[
:Select OK to end
]
Press [Cancel] to return.
Lock the control panel buttons.
[
or
: Enter setting]
[
: Select On/Off
[
]
:Select OK to end
Press [Cancel] to return.
Press
and switch with
and
. Off/ CC1/ CC2/CC3/CC4/T1/T2/T3/T4
Press
. (The password and user logo are not reset.)
Resets all adjustments and settings to their factory settings.
Password setting
p.32
Press
.
Password registration/Password setting
41
p.21
(Ceiling)
(Rear ceiling)
Standard
High
]
[
: Confirm]
]
[
: Confirm]
Yes
No
p.16 p.17
Advertisement
Table of Contents
