Disc Playback; Playback Procedure - Toshiba D-VR5SU Owner's Manual

Disc playback

Playback procedure

NOTES:
• If a non-compatible disc is loaded, "IN-
CORRECT DISC", "REGION CODE
ERROR" or "PARENTAL ERROR" will
appear on the TV screen according to
the type of loaded disc. In this case, check
your disc again (See pages 9 and 26).
• Some discs may take a minute or so
to start playback.
• A prohibition symbol " " may appear
at the upper right of the screen. This
symbol means either the feature you
tried is not available on the disc, or the
DVD/VCR can not access the feature
at this time. This does not indicate a
problem with the DVD/VCR.
• When you set a single-faced disc la-
bel downwards (ie. the wrong way up)
and press PLAY or OPEN/CLOSE,
"READING" will appear and then it will
change to "NO DISC".
• Some playback operations of DVDs
may be intentionally fixed by software
producers. Since this DVD/VCR plays
DVDs according to the disc contents
the software producers designed,
some playback features may not be
available. Also refer to the instructions
supplied with the DVDs.
• When playing DTS-encoded Audio
CDs, excessive noise will be heard
from the analog stereo outputs. To
avoid possible damage to the audio
system, the consumer should take
proper precautions when the analog
stereo outputs of the DVD/VCR are
connected to an amplification system.
34
2J40101A P34-40
Preparation:
• Turn ON the TV and set to the video input mode.
• Press DVD to select the DVD mode. (The DVD indicator will light.)
NOTE: It is impossible to switch to the VCR mode while DVD is
played back.
1
Press OPEN/CLOSE.
The disc tray will open.
2
Place a disc onto the tray.
Hold the disc, position it with the
printed label side up, align it with
the guide and place it in its proper
position.
3
Press OPEN/CLOSE to close the
disc tray.
"READING" appears on the screen
and some discs start playback au-
tomatically.
• A menu screen may appear on
the TV screen if the disc has a
menu feature. In this case, press
, ,
4
Press PLAY to start playback.
5
Press STOP to end playback.
• The DVD/VCR memorizes the stopped point, depending on
the disc. "
" " keeps blinking in the display window until the playback is
stopped completely. Press PLAY to resume playback (from the
scene point).
• If you press STOP again ("
VCR will clear the stopped point.
6
Then press OPEN/CLOSE.
The disc tray opens.
Remove the disc and press ON/STANDBY.
The disc tray closes automatically and DVD/VCR turns off.
34
, or ENTER to operate a menu feature.
" appears on the screen for approx. 4 seconds.
" appears on the screen), the DVD/
3/4/06, 10:44 AM
READING