Chapter 8: Troubleshooting; General Troubleshooting - Toshiba 62HM196 User Manual

HM196_EN.book Page 76 Tuesday, May 30, 2006 2:18 PM

General troubleshooting

Before calling a service technician, please check this chapter
for a possible cause of the problem and some solutions you can
try.
Black box on screen
The Closed Caption feature is set to one of the Text
•
modes (T1, T2, T3, or T4). Set the Closed Caption
feature to Off (- page 43).
TV plays a recorded announcement when LEDs are blinking
When certain non-standard conditions occur, the LEDs
•
on the TV will blink and the TV will play a recorded
"voice announcement" describing the condition (see
"LED indications" on page 80 for details).
TV stops responding to controls
• If the TV stops responding to the controls on the remote
control or TV control panel and you cannot turn off the
TV, press and hold the POWER button on the TV control
panel for 5 or more seconds to reset the TV.
Other problems
• If your TV's problem is not addressed in this
Troubleshooting section or the recommended solution
has not worked, use the Reset Factory Defaults procedure
(- page 31).
TV will not turn on
Make sure the power cord is plugged in, and then press
•
p.
The remote control batteries may be dead. Replace the
•
batteries or try the control panel buttons.
If you have recently replaced the lamp unit, make sure the
•
lamp unit and lamp unit door are installed properly
(- pages 81–83).
• The lamp unit may need to be replaced (- pages 81–83).
Also see "LED indications" (- page 80).
• If the TV is powered off and then quickly on again when
the lamp unit is hot, it may take several minutes for the
picture to appear on-screen. This is a property of DLP TV
lamp technology and is NOT a sign of malfunction. For
details, see "IMPORTANT NOTICE ABOUT HOT
LAMP RESTART" (- page 2).
76

Chapter 8: Troubleshooting

Picture problems
General picture problems
Noisy picture
Video Input Selection problems
Cannot view external signals or channel 3 or 4
Poor color or no color
POP problems
Check the antenna/cable connections (- Installation
•
Guide).
Press + on the remote control or TV and select a valid
•
video input source (- page 32). If no device is
connected to a particular input on the TV, no picture will
display when you select that particular input source. For
device connection details, see the Installation Guide.
• Antenna reception may be poor. Use a highly directional
outdoor antenna (if applicable).
• The station may have broadcast difficulties. Try another
channel.
• Adjust the picture qualities (- page 42).
If you are using a VCR, make sure L on the remote
•
control is set to the correct mode (see item 22 on page
13).
• If you have two VCRs connected to your TV, make sure
you have not connected the same VCR to the TV's output
and input connections at the same time (- Installation
Guide).
• Do not connect both a standard video cable and an S-
video cable to the same set of VIDEO inputs (VIDEO 1,
or VIDEO 2) at the same time (- Installation Guide).
• If you are watching an tuned analog channel (off-air
broadcast or Cable TV), you can set the CableClear
feature to AUTO to reduce visible interference in the TV
picture (- page 54).
• If the Input Selection window does not appear when
you press + on the remote control or TV, press + a
second time, which will change to the next video input
source and display the Input Selection window.
If you cannot view signals from external devices
•
connected to VIDEO 1, VIDEO 2, or ColorStream
from channels 3 or 4, make sure the Input Lock is set to
Off (- page 50).
• The station may have broadcast difficulties. Try another
channel.
Adjust the Tint and/or Color (- page 42).
•
®
• When the ColorStream signal source is active, the
VIDEO OUT terminal does not output video. To receive
video from the VIDEO OUT terminal, a standard video
or S-video IN connection must be used instead of the
®
ColorStream connections.
• If you label all of the inputs as "Hide," the POP feature
will be disabled. If you then attempt to access the POP
feature, the message "Not Available" will appear on-
screen (- page 40).
®
®
, or
HM196 (E/F) Web 213:276