Using The Stablesound ® Feature; Turning Off The Built-In Speakers; Selecting The Optical Audio Output Format; Hm196 (E/F) Web 213:276 - Toshiba 62HM196 User Manual

HM196_EN.book Page 46 Tuesday, May 30, 2006 2:18 PM
Using the StableSound
The StableSound ® feature limits the highest volume level to
prevent extreme changes in volume when the signal source
changes (for example, to prevent the sudden increase in
volume that often happens when a TV program switches to a
commercial).
To turn on the StableSound
Press Y and open the Audio menu.
1
Highlight Audio Settings and press T.
2
3
In the StableSound field, select On.
Audio Settings
Bass
Treble
Balance
StableSound
Reset
To save the new settings, highlight Done and press T.
4
To revert to the factory defaults, highlight Reset and
press T.
Note: The RESET function returns your audio adjustments
to the following factory settings:
Bass . . . . . . . . . center (50)
Treble. . . . . . . . center (50)
Balance . . . . . . center (0)
StableSound. . . Off
To turn off the StableSound feature:
Select Off in step 3 above.

Turning off the built-in speakers

You can use this feature to turn off the TV speakers when you
connect an audio system to your TV (- "Connecting a digital
audio system" and "Connecting an analog audio system" in the
Installation Guide).
To turn off the built-in speakers:
Press Y and open the Audio menu.
1
Highlight Audio Setup and press T.
2
3
In the Speakers field, select Off.
Audio Setup
MTS
Language
Speakers
Optical Output Format
Reset
To save the new settings, highlight Done and press T.
4
To revert to the factory defaults, highlight Reset and
press T.
To turn on the built-in speakers:
Select On in step 3 above.
46
Chapter 5: Using the TV's features
® feature
®
feature:
100
100
0
On
Done
Stereo
English
Off
Dolby Digital
Done

Selecting the optical audio output format

You can use this feature to select the optical audio output
format when you connect a Dolby Digital decoder or other
digital audio system to the Optical Audio Out terminal on
the TV (- "Connecting a digital audio system" in the
Installation Guide).
To select the optical audio output format:
Press Y and open the Audio menu.
1
Highlight Audio Setup and press T.
2
3
In the Optical Output Format field, select either
Dolby Digital or PCM, depending on your device.
Audio Setup
MTS
Language
Speakers
Optical Output Format
Reset
To save the new settings, highlight Done and press T.
4
To revert to the factory defaults, highlight Reset and
press T.
Stereo
English
On
Dolby Digital
Done

HM196 (E/F) Web 213:276