Connecting A Device To The Ir Out Infrared Terminal Using The Ir Blaster Cable For Ir Pass-Through Device Control - Toshiba Regza 42ZV650U Owner's Manual

Integrated high definition lcd television
Hide thumbs Also See for Regza 42ZV650U:
Table of Contents

Advertisement

Connecting a device to the IR OUT
infrared terminal using the IR
blaster cable for IR pass-through
device control
You can use the TV's IR OUT terminal (infrared
pass-through) to remotely operate (through the TV)
many infrared remote-controlled devices (such as
Toshiba infrared remote-controlled VCRs or DVD
players) enclosed within an entertainment center or
similar cabinet. Without the IR OUT connection, the
device typically would need to be visible to operate
it remotely.
You will need:
•dual-wand IR blaster cable (- page 12)
•other audio/video cables as required to connect the
device(s) to the TV (- pages 13, 14 and 16)
Front of IR-controlled DVD player (for example)
Front of IR-controlled audio device (for example)
Infrared
sensor
IR blaster cable wand
(approx.1 inch from device)
TV upper back panel
Chapter 2: Connecting your TV
Chapter 2: Connecting your TV
To connect the IR blaster cable:
1
Locate the infrared sensor on the front of your
device. This sensor is marked on some devices.*
2
Align one of the IR blaster cable's wands about
1 inch away from the infrared sensor on the
front of the device and attach it using double-
sided mounting tape. If you have a second
device, attach the second wand in a similar
manner. (See illustration.)
Note: If you do not have a second device, coil the
second wand with a rubber band and leave it behind
the TV.
3
Plug the IR blaster cable's plug into the TV's IR
OUT terminal.
To control the device(s):
Point either the device's remote control or the TV
remote control (that you previously programmed to
operate the device; - Chapter 3) toward the front of
the TV and press the button for the desired function.
The signal passes from the remote control through
the TV to the device via the IR blaster cable.
Note:
• If you use the device's remote control to operate the
device, you also will need to use the TV's remote control
to operate the TV.
• The IR pass-through feature does not support all
IR-controlled devices; satisfactory performance may not
be attainable with certain devices.
*If you cannot locate the device's infrared
sensor:
1 Turn OFF the device.
2 Starting at the lower left corner of the device,
place the end of the device's remote control
(with the infrared emitter) so it touches the
front of the device and press POWER. (Do not
use the TV's remote control for this step.)
3 If the device turns on, the point at which the
remote control touched the device is the
location of the sensor.
4 If the device does not turn on, move the remote
control slightly to the right and press POWER
again.
5 Repeat step 4 until you locate the device's
infrared sensor.
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Regza 47zv650uRegza 55zv650u55zv650u - 54.6" lcd tv

Table of Contents