Chapter 4: Setting Up Your Tv; Selecting The Menu Language; Configuring The Antenna Input Sources For The; Ant 1 And Ant 2 Terminals - Toshiba 42HL196 Operating Manual

Selecting the menu language

You can choose from three different languages (English,
French, and Spanish) for the on-screen display of menus and
messages.
Note: The TV Guide On Screen
regardless of the language selected in this menu.
To select the menu language:
1
Press Y and open the Preferences menu.
2
Highlight Menu Language and press c.
3
Press B or b to select your preferred menu language and
press T.
Preferences
Closed Caption Mode
Closed Caption Advanced
Input Labeling
Menu Language English
Channel Browser Setup
Navigate
ENTER Select
4
Press O to close the Preferences menu.
24

Chapter 4: Setting up your TV

™ menus are in English,
Off English
Français
Español
Back Exit
CH RTN EXIT
Configuring the antenna input
sources for the ANT 1 and ANT 2
terminals
To configure the ANT 1 and ANT 2 input sources:
1
Press Y and open the Setup menu.
2
Highlight Installation and press T.
Setup
Installation
Sleep Timer
On/Off Timer
PC Settings
PC Audio
HDMI 1 Audio
Slide Show Interval
Navigate ENTER Select
3
(A new set of Installation menu icons will appear, as
shown below.) Open the Terrestrial menu, highlight
Input Configuration, and press T.
Note: The Terrestrial menu may not be accessible (items
will be "grayed out") in some instances (for example, if a
cable box is connected to the ANT 1 input or if one of the
VIDEO modes is the current input during TV Guide
On Screen ™ setup).
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
Navigate ENTER Select
4
Press B or b to highlight Antenna 1 In, and press C or
c to select the input source (Cable or Antenna) for the
ANT 1 input on the TV.
Note: If a cable box is connected to the ANT 1 input
during TV Guide On Screen
menu will not be accessible, including the input source for
ANT 1, which will automatically display "Cable Box."
5
Press b to highlight Antenna 2 In and then C or c to
select the input source (Cable or Antenna) for the
ANT 2 input on the TV, if applicable. If you have not
connected anything to the ANT 2 input, skip this step.
Input Configuration
Antenna 1 In
Antenna 2 In
Cancel
6
To save your new settings, highlight Done and press T.
To revert to your original settings, highlight Cancel and
press T.
No
Auto
2 Sec
CH RTN Back EXIT Exit
CH RTN Back EXIT Exit
™ setup, the entire Terrestrial
Cable
Antenna
Done