Download Print this page

Drolo stamme n V4 Manual

Download this manual

Stamme[n] is a pedal that originated from an

initial idea of Kent Sommer (aka UglyCasanova

and now digitalflorafx). He asked me if I could

make him a pedal that would loop short

samples and had tap tempo. It seemed like a

fun project and while working on it I decided

to add more features. In the end it became an

official drolo product and I really want to

thank Kent for his input, ideas and the nice

chats.

From that initial tap tempo micro looper idea,

the pedal has evolved over the years into a

micro looper / time stretcher / glitch delay /

tape machine / infinite sustainer / reverb.

stamme[n] V4

Need help?

Do you have a question about the stamme n V4 and is the answer not in the manual?

Page 1 It seemed like a fun project and while working on it I decided to add more features. In the end it became an official drolo product and I really want to thank Kent for his input, ideas and the nice chats.
Page 2 The looping modes The hold modes ML (tap tempo micro looper) These modes are in fact reverbs that can be set to sustain infinitely (well almost, they do start to degrade slowly after a few minutes). The length of the recording can be set manually with the control knob or by tapping the tempo with the tap switch.
Page 3: Basic Operation
‘live’ ones, would.The range of pitch spans over two octaves. that are constantly regenerating and the hold effects become actual reverb effects. drolo...
Page 4: Sample Rate
wet/dry: Controls Controls the level of the wet and dry signals. Unity gain is around noon position. sample rate expression power audio audio Controls the sample rate at which the DSP chip will run. It goes from input (TRS) supply (9v) output input around 10kHz to 40kHz.
Page 5 EXP input: Power Supply: Can be used to externally control the pedal’s control knob The power supply needs to be 9V/100mA center negative or sample rate knob with an expression pedal or CV source. like the com- monly used guitar pedal power supplies: When something is connected to the exp input, the control or sample rate knobs can be used to define the max range of the exp input.