Table of Contents
Advertisement
NOTE
Once you have positioned your cursor, you can click it into place by
either double-tapping the TouchPad or clicking the control buttons.
Scrolling with the TouchPad
There are two active regions on the TouchPad
scroll as you would with any wheel device on a mouse or trackball.
To scroll vertically, run your finger up or down along the right edge
of the TouchPad. To scroll horizontally, run your finger along the
bottom edge of the TouchPad. This feature can be disabled or
changed in the Mouse Properties dialog box.
Control buttons
When a step instructs you to click or choose an item, move the
cursor to the item, then press and release the primary (left-hand)
button. To double-click, press the primary button twice in rapid
succession. The primary button usually corresponds to the left
mouse button.
The function of the secondary (right-hand) button depends on the
program you are using. It usually corresponds to the right mouse
button ("right-clicking"). Check your program's documentation to
determine whether it uses the right mouse button.
Disabling or enabling the TouchPad
The TouchPad
disable TouchPad setting, press
disables the TouchPad. For more information, see
or enabling the TouchPad" on page
Using external display devices
Your computer comes with a built-in display, but you can also
connect an external monitor or projector via the RGB (monitor) port.
Before connecting an external monitor or video projector, configure
your computer for the type of device you are connecting. To do this,
refer to the documentation for your operating system and devices.
Using external display devices
Because the TouchPad is much smaller than the display screen,
moving your cursor across the screen often means having to move
your finger several times across the TouchPad in the preferred
direction.
™
™
is enabled by default. To change the enable/
Getting Started
™
™
Fn
+
F9
. This hot key enables/
194.
63
that allow you to
"Disabling
Advertisement
Table of Contents
