Oven Light; Troubleshooting - Whirlpool  WFG710H0AE Use & Care Manual

Gas range
Table of Contents

Advertisement

Available languages

Available languages

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
PROBLEM
Nothing will operate
Surface burners will not
operate
Surface burner flames are
uneven, yellow and/or noisy
Excessive heat around
cookware on cooktop
16

TROUBLESHOOTING

to possibly avoid the cost of a service call.
In Canada, reference the Customer Service section at www.whirlpool.ca.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
POSSIBLE CAUSES
Power supply cord is unplugged.
Household fuse is blown or a
circuit breaker is tripped.
Main or regulator gas shutoff
valve is in the off position.
The range is improperly
connected to the gas supply.
The control knob is not set
correctly.
Air in the gas lines
Clogged burner ports
Clogged burner ports
Burner caps positioned
improperly
Range converted improperly
Cookware that is not the proper
size

Oven Light

2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
www.whirlpool.com
WARNING
SOLUTIONS
Plug into a grounded 3 prong outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
See the Installation Instructions.
Contact a trained repair specialist or see Installation
Instructions.
Push in knob before turning to a setting.
If this is the first time the surface burners have been used, turn
on any one of the surface burner knobs to release air from the
gas lines.
See "Sealed Surface Burners" section.
See "Sealed Surface Burners" section.
See "Sealed Surface Burners" section.
If propane gas is being used, contact a service technician or
see cover for contact information.
The cookware should be centered above the burner with the
bottom sitting level on the grate. The flame should be adjusted
so that it does not extend up the sides of the pan.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

 wfg710h0ahWfg720h0as wfg710h0as

Table of Contents