Table of Contents
Advertisement
2 Safety instructions
2.1 About this chapter
The test device described in the following has been manufactured according to
good engineering practice. However, there is still a risk of personal injury and/or
damage to property if you do not observe this chapter and the safety instructions
in this documentation.
▶
Read this documentation completely and thoroughly before working with the
product.
▶
Keep this documentation in a location where it is accessible to all users at all
times.
▶
Always include the required documentation when you pass the service case
with the test device on to third parties.
2.2 Intended use
The test device is suitable for activating and functional testing of Bosch Rexroth
SY(H)DFEx systems with integrated electronics and 11+PE connection.
The technical data of the device have to be observed without exception, and the
specified ambient conditions have to be adhered to, see chapter 15 "Technical
data" on page 28.
The use in potentially explosive atmospheres is not permitted.
The device is provided for temporary use in a controlled electromagnetic
environment (according to EN 61326-1, table 3, testing according to EN 61326-
2-1) on hydraulic industrial equipment for commissioning, analyzing, testing and
servicing of hydraulic valves in plant.
Dry and clean ambient conditions have to be ensured.
2.3 Improper use
Any use other than described in the section "Intended use" is considered as
improper and is therefore not permitted und renders any warranty claims null and
void. It is also regarded as improper use if the test device is operated outside the
indicated performance limits and operating conditions, especially the prescribed
ambient conditions.
The test device is not provided for use in Class B environments (domestic/
residential). Should the test device nevertheless be used in a domestic/residential,
controlled electromagnetic environment (emission limit values of class B), further
measures have to be taken to prevent electromagnetic interference.
Bosch Rexroth AG does not assume any liability for damage caused by improper
use. The user assumes all risks involved with improper use.
2.4 Qualification of personnel
The activities described in this documentation require basic knowledge of
electrical installation, control technology, programming and hydraulics as well
as knowledge of the appropriate technical terms. In order to ensure safe use,
these activities may only be carried out by an expert in the respective field or an
instructed person under the direction and supervision of an expert.
Safety instructions
RE 29689-B/11.2019; VT-PDFE-1X..., Bosch Rexroth AG
7/32
Advertisement
Table of Contents
