Table of Contents
Advertisement
7 Installation
Condensed water!
Risk of short-circuit
▶
Allow the test device to acclimatize for several hours to prevent the formation
of condensed water in the housing of the test device.
Penetrating humidity!
The housing of the test device is enclosed. Nevertheless, according to the
applicable ingress protection class, fluids may enter and lead to faults and short-
circuit. This will result in the fact that safe operation of the test device can no
longer be ensured.
▶
When working with the test device, always ensure that no fluids can enter the
electronics housing.
Major potential differences!
Risk of destroying the electronics by connecting or disconnecting plug-in
connectors under voltage.
▶
Switch off the power supply to the relevant system part before assembling the
device or when connecting and disconnecting connectors.
7.1 Unpacking
Dispose of the packaging in accordance with the national regulations of your
country.
7.2 Installation conditions
▶
For installing the product always observe the environmental conditions
specified in the technical data sheet.
NOTICE: The environment must be free from aggressive substances (acids, bases,
corrosive agents, salts, metal vapors, etc.) which may enter the device despite
compliance with the relevant protection class.
▶
Before commissioning, make sure that all plug-in connections are correctly
installed and undamaged to ensure that no fluids or foreign particles can enter
the product.
7.3 Required tools
No special tools are required for the installation.
7.4 Before use
▶
Before using the test device, check compliance of the type designation on the
nameplate with your order or job order number.
7.5 Place of use
The test device should not be installed next to power electronics (e.g. frequency
converters, etc.)
NOTICE
RE 29689-B/11.2019; VT-PDFE-1X..., Bosch Rexroth AG
Installation
21/32
Advertisement
Table of Contents
