Table of Contents
Advertisement
4. Step on brake pedal (8) and depress parking brake switch (9)
to the OFF position to release the parking brake. Check that
when depress parking brake switch (9) to the OFF position,
the service indicator (2) goes OFF.
NOTE: When starting to move on a slope, turn clutch cut posi-
tion switch (14) to the OFF position (the clutch is en-
gaged). While stepping on the brake pedal, depress the
accelerator pedal (12). Slowly release the brake pedal (8)
to allow the machine to easily start moving on a slope.
5. Manual transmission mode (M):
After moving forward/reverse lever (10) to either forward (F)
or reverse (R) position, move the transmission gear switch
(11) to the desired position. The transmission gear position
can be shifted in 4 stages in the forward mode and 3 (or 4)
stages in the reverse mode respectively. Select the most ap-
propriate transmission gear position according to the type
of the work engaged in or the driving road conditions.
6. Auto transmission mode (L, N, or H):
When operating the machine in the auto transmission
mode (L, N, and H), move the forward/reverse selector lever
to either the forward (F) or reverse (R) position. Select the
gear stage in which the machine will mainly be operated in
hereafter. Then, select the auto transmission mode by oper-
ating transmission mode selector (13).
Position M: Manual shift (The transmission gears are shifted
with the shift switch.)
(ZW180)
Auto 1-4L: To increase work volume with less fuel consump-
tion
(Applicable to general works such as excavation,
and loading, long distance movement, climbing
slopes and snow removal in the 2nd-gear stage)
Auto 2-4N: To primarily increase work volume
(Applicable to loading works and snow removal
in the 3rd or 4th gear stage auto shift mode)
Auto 1-4H: To primarily increase work volume
(Applicable to excevation, and loading works and
climbing slopes in the 3rd or 4th gear stage auto
shift mode)
(ZW220, 250, 310)
Auto L:
To primarily save the fuel consumption
(Suitable to operation performed with frequent
long flat distant driving)
Auto N:
To increase work volume with less fuel consump-
tion
(Suitable to normal loading work)
Auto H:
To primarily increase work volume
(Suitable to operation in a steep upslope work site
or in a work site where the first driving gear range
is frequently used)
NOTE: In case the machine is equipped with the 3-stage gear-
shift transmission in the reverse mode, even if the 4-stage
gearshift position is selected, the drive speed remains
unchanged from that of the 3-stage gearshift.
7. Release brake pedal (8) and step on accelerator pedal (12).
DRIVING THE MACHINE
10
11
4-3
8
13
9
14
ZW180
ZW220, 250, 310
2
M4GF-01-001
9
12
M4GB-01-004
M4GB-01-046
13
M4GB-01-047
13
M4GB-01-047
Advertisement
Chapters
Table of Contents
