Pc Display; Using Your Tv As A Computer (Pc) Display; Display Modes - Samsung HP-T5044 Owner's Instructions Manual

PC Display

Using Your TV as a Computer (PC) Display

Setting Up Your PC Software (Based on Windows XP)
The Windows display-settings for a typical computer are shown below. The actual screens on your PC will probably be
different, depending upon your particular version of Windows and your particular video card. However, even if your actual
screens look different, the same basic set-up information will apply in almost all cases. (If not, contact your computer or
video card manufacturer.)
1 First, click on Control Panel on the Windows start menu.
2 When the control panel window appears, click on Appearance and Themes and a
display dialog-box will appear.
3 When the control panel window appears, click on Display and a display dialog-box
will appear.
4 Navigate to the Settings tab on the display dialog-box.
The correct size setting (resolution)
Optimum: 1360 x 768 pixels
If a vertical-frequency option exists on your display settings dialog box, the correct
value is 60 or 60 Hz. Otherwise, just click OK and exit the dialog box.

Display Modes

If the signal from the system equals the standard signal mode, the screen is adjusted automatically. If the signal
from the system doesn't equal the standard signal mode, adjust the mode by referring to your videocard user
guide; otherwise there may be no video. For the display modes listed below, the screen image has been optimized
during manufacture.
D-Sub Input
Resolution Vertical Frequency (Hz)
720 x 400
VGA
640 x 480
SVGA 800 x 600
XGA 1024 x 768
WXGA 1360 x 768
HDMI/DVI Input
Resolution Vertical Frequency (Hz)
720 x 400
VGA
640 x 480
SVGA 800 x 600
XGA 1024 x 768
WXGA 1360 x 768
• The interlace mode is not supported.
• The TV operates abnormally if a non-standard video format is selected.
• The table above conforms to IBM/VESA regulations and is based on using the Analog Input.
• " " mark means that this mode can be supported.
✔
• For the HP-T5044, PC text quality is optimum in WXGA mode (1360 x 768@60Hz).
➢
(Three pixels on left, right, top and bottom will be grayed out at the resolution setting of 1360x768@60Hz. This is not a mechanical problem
but a result caused by the pixel difference between the standard resolution and the PDP panel.)
• When this TV is used as a PC display, 32-bit color is supported.
• Depending on the manufacturer, your PC display screen might appear different. (and depending on your particular version of Windows.)
Check your PC instruction book for information about connecting your PC to a TV.
• If a vertical and horizontal frequency-select mode exists, select 60Hz (vertical) and 48.4KHz (horizontal).
• In some cases, abnormal signals (such as stripes) might appear on the TV screen when the PC power is turned off (or if the PC is disconnected).
If so, press the SOURCE button on the remote control or TV panel to enter a VIDEO mode. Also, make sure that the PC is connected.
Horizontal Frequency (kHz)
70.087 31.469
59.940 31.469
72.809 37.861
75.000 37.500
60.317 37.879
72.188 48.077
75.000 46.875
60.004 48.363
70.069 56.476
75.029 60.023
60.015 47.712
Horizontal Frequency (kHz)
70.087 31.469
59.940 31.469
60.317 37.879
60.004 48.363
60.015 47.712
Vertical Polarity
N
N
N
N
P
P
P
N
N
P
P
Vertical Polarity
N
N
P
N
P
English - 45
Horizontal Polarity HP-T5044
P
✔
N
✔
N
✔
N
✔
P
✔
P
✔
P
✔
N
✔
N
✔
P
✔
P
✔
Horizontal Polarity HP-T5044
P
✔
N
✔
P
✔
N
✔
P
✔