AEG IDK84454IB User Manual page 71

food, because the temperature does not exceed that of the set
level.
This function is available for power levels 1-8 .
Activation:
• push and hold the Selection zone (3), the desired power
• on display appears a " "
Power Limitation
The Power Limitation function allows the product to be used
while limiting its maximum consumption.
Note : the limit must be set when the hob is off, without
pressing the key , at the time of the hob's connection to
the electrical network, or when the electrical network itself is
reconnected, within the following 2 minutes.
To set the Power Limitation:
• push and hold the keys
• simultaneously swipe onto the selection zones
FL and RL
from left to right, then push and hold down the area
corresponding to the last power level, until you hear a short
beep, the Timer (15) display shows the symbols "CF6", to
indicate that it is possible to run the setup
• the FL zone display shows the current setting**
0 = 7.4 KW
1 = 4.5 KW
** by default, the limit is set to 7.4 KW
• to change the Power Limitation settings, swipe onto the
selection zones FL
• to save the change made, push the keys
second;
a beep will be emitted to confirm the setting; the function will close.
(13).
+ , until you hear a short beep
,
+ , for 1
USING THE EXTRACTOR FAN
Power-on
Press (touch) hob/ extractor
The indicator light will turn on to indicate that the hob/extractor
is ready for use
Press again to turn off
Note: This function has priority over the others.
Switching on the extractor fan:
Touch (press) the Selection bar (6) to activate the extractor
fan
Extraction speed (power):
Touch and scroll along the Selection bar (6):
to the right to increase the speed (power) of the extractor fan (0-10);
to the left to decrease the speed (power) of the extractor fan (10-0);
Timer
Activation/Regulation of Timer function for the extractor fan
•
Select the extractor fan (speed 0).
•
Press (8) to access the Timer function (from any speed)
•
Regulate the duration of the Timer:
press the selector , to increase the automatic shut-down time
press the selector , to decrease the automatic shut-down time
the display (15) will show the countdown,
Note: on the side of the display of the extractor fan, with the Timer
in use, the following symbol will appear
When the timer has finished the countdown, there is an acoustic
signal (for 2 minutes, or it will stop when one of the buttons on the
hob is pressed), while the display (15) will flash, with the symbol
"
. ".
To switch off the Timer:
•
select the cooking zone
•
set the value of the timer to " " , by means of
Not: the function remains active if no other key is pressed in the
meantime.
Filter saturation indicator
The hood indicates when filter maintenance is needed:
Grease filter the (17) LED lights up
Activated carbon odour filter the
Reset filter saturation
After carrying out maintenance on the filters (grease and/or
activated carbon) hold down the key
the (17) LED turns off and the count restarts.
Activation of activated carbon odour filter saturation
indicator
This indicator is normally deactivated.
To activate it, proceed as follows:
(19)
(17) LED flashes
(7);