After Installation - Pioneer ND-PS1 Instruction Manual

• Do not shorten any leads. If you do, the protection circuit (fuse holder, fuse resistor or filter, etc.) may fail
to work properly.
• Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts
can cause malfunctions.
• Never feed power to other electronic products by cutting the insulation of the power supply lead of
this product and tapping into the lead. The current capacity of the lead will be exceeded, causing
overheating.
• Use this unit with a 12-volt battery and negative grounding only. Failure to do so may result in a fire or
malfunction.
• The graphical symbol
• When replacing the fuse, be sure to only use a fuse of the rating prescribed on the fuse holder.
• To avoid a short in the electrical system, disconnect the (-) battery cable before installation.
• Secure the wiring with cable clamps or adhesive tape. Wrap adhesive tape around wiring that comes
into contact with metal parts to protect the wiring.
• Before drilling any mounting holes, always check behind where you want to drill the holes. Do not drill
into the gas line, brake line, electrical wiring, or other important parts.
• Do not perform installation in rain or fog.
• Make sure that the device works properly after installing this product. <Test Method: Refer to TEST
AFTER INSTALLATION>
placed on the product means direct current.
41