Usb Port; Card Reader - Silvercrest SAR 28 A1 Operating Instructions Manual

If there is no further input for 2 seconds, an automatic search for stations matching
the PTY entry starts. The search stops when the fi rst station is found. The selected
PTY entry blinks in the display
Disabling / enabling the PTY function
♦ Press the MD/PTY
The PTY symbol is shown on the display with the last PTY entry selected
(e.g. POP M).
Only stations with the PTY ID currently selected are included in the station search.
♦ Press the MD/PTY button again to disable the PTY search. PTY is no longer
shown on the display.
Station search by PTY ID
♦ If you do not input anything for 2 seconds whilst a PTY ID is being dis-
played, an automatic search for stations matching this PTY ID is started.
If no stations matching this PTY ID are found, PTY NONE is shown briefl y and the
search then ends at the station last set.

USB port

The device can process USB data carriers up to 16 GB.
Connecting data carriers
♦ Push the USB port protective cap to the right.
♦ Connect your USB device to the port.
♦ To protect against dirt, replace the protective cap on the USB port when no
USB device is connected.

Card reader

The device can process SD/MMC memory cards up to 2 GB, and SDHC
memory cards up to 32 GB.
Connecting data carriers
♦ Press the
device (see also Section "Removing the face plate").
♦ Push a memory card into the memory card slot with the lettering pointing
upwards until it engages.
SAR 28 A1
during the channel search.
5
3 button to activate the PTY search.
button to unlock the face plate and remove it from the
GB
CY
19