Installing The Water Dispenser Line - Samsung RSA1NHMH User Manual

. After adjusting the doors, turn the nut
the bolt, then tighten the bolt again with the wrench
If you do not secure the nut firmly, the bolt may release.
CHECKing tHE watEr DisPEnsEr LinE (oPtionaL)
A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote
better health, the Samsung water filter removes unwanted particles from your water. However, it does not
sterilize or destroy microorganisms. You will need to purchase a water purifying system to do that.
In order for the icemaker to operate properly, water pressure of 138 ~862 Kpa is required. Under normal
conditions, a 170 cc paper cup can be filled in 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 138 Kpa), you can install a booster
pump to compensate for the low pressure.
Make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water
dispenser lever until the water runs from the water outlet.
Water Line installation Kits are included with unit. You can find it in freezer drawer.

instaLLing tHE watEr DisPEnsEr LinE

Parts for water line Installation
Water line fixer
and screws
Connecting to the water supply line
Connect the water pipe with coupler and tap.
1. Close the main water tap.
. Connect coupler "A" to the tap. Note:
WARRANTY INFORMATION
This water line installation is not covered by the
refrigerator or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the
risk of expensive water damage.
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase
the right couplers fittings.
1_ setting up
clockwise
1
to fix the nut in place

Pipe
Water line
connector
The water line must be connected
until it reaches the lower end of
.
1

Wrench

bolt
1
Nut
Filter
lock-clip
Filter
CAUTION
to the cold water pipe.
If it is connected to the hot
water pipe, it may cause the
filter to malfunction.
COUPLER "A"
TAP