Operation - Makita 6924N Instruction Manual

Installing the outer and inner
sleeves
Hold the inner sleeve with the pin facing upward. Place
the outer sleeve over the inner sleeve. Press the pin to
allow inserting the inner sleeve, then release the pin to
secure the inner sleeve.
► 1 . Outer sleeve 2. Pin 3. Inner sleeve
Insert the outer and inner sleeves into the tool while
rotating the inner sleeve alternately clockwise and
counterclockwise until there is no gap between the
outer sleeve and the tool. See the figure. Then tighten
the two screws securely.
3
4
► 1 . There should be no gap between the outer
sleeve and the tool. 2. Inner sleeve 3. Outer sleeve
4. Screw
1
2
3
2
1

OPERATION

Bolt installation
Slip the tool onto the bolt so that the inner sleeve com-
pletely covers the bolt tip.
► 1 . Inner sleeve 2. Bolt tip
CAUTION:
• Be careful when fitting the sleeve onto the bolt
tip. Striking the tip can damage it so that it will
no longer fit inside the sleeve properly.
• First tighten bolts preliminarily by using a hand
wrench and then tighten them with this tool. Use
this tool only after preliminary tightening without
starting the tightening with this tool.
Keep forward pressure on the tool while sliding it further
forward until the outer sleeve fits completely over the
nut. If the tool fails to fit completely over the nut, twist
the tool slightly right and left while pushing forward.
► 1 . Outer sleeve 2. Nut
5 ENGLISH
1
2
1
2