Operation; Saving Energy; Setting The Temperature Unit - Silvercrest SWTS 65 A1 Operating Instructions Manual

Check that the shelves
locking appliances on the sides of the shelves
the rear.
Insert the plug into the mains power socket.
You will hear a beep and the display
the interior of the appliance. The appliance starts the cooling process, a
temperature of 18 °C is preset by default.
The appliance is now ready for use.

Operation

Saving energy

Please observe the following tips to achieve optimum cooling performance with
the lowest possible energy consumption:
■ Do not select a temperature which is colder than necessary. The colder the
set temperature, the more energy the appliance consumes.
■ The cooler the ambient air, the less energy the appliance needs to produce
to reach the desired temperature. Do not place the appliance near heat
sources such as radiators, dishwashers or cookers and avoid direct sunlight.
Ensure that there is adequate ventilation.
■ Make sure that the door
■ Do not leave the door
from escaping.

Setting the temperature unit

The appliance can display the temperature in either °C (Celsius) or °F (Fahrenheit).
By default, the temperature is shown in °C on the display
To change the unit, press and hold
on the display
NOTE
► The same button is also used to operate the light
ton
The light
► If you are not sure which temperature unit is currently being shown, change
the display again. The higher value is the temperature in °F and the lower
value is the temperature in °C.
SWTS 65 A1
are correctly positioned in the guide rails. The two
is always properly closed.
open for a long period of time to prevent the cold
changes.
briefly again, if necessary, to switch the light
switches off automatically after 10 minutes.
must point downwards at
shows the current temperature of
.
button until the temperature shown
° C | ° F
. Press the
on or off again.
GB │ IE
but-
° C | ° F
│ 31 ■