Samsung YP-T5H Quick Manual

YP-T5 Quick Guide

Location of Controls

Display
Loop Repeating Button
Recording Button
Microphone
ENC Jack
USB Cable
Connection Port
Turning Power On and Off
Power On : Press the button to turn on the power.
Power Off : Press and hold the button to turn off the power.
Pausing Music
Press the button to pause playback.
If no buttons are pressed within 10 seconds(changes depending on settings),
the yepp automatically powers off.
While in Pause mode, briefly press again to resume playback.
1
Neck strap Hook
MENU, Navigation button/
Move to Track/Speed Search/
Volume Button
Play/Pause Button
Hold Switch
Earphone Jack
Battery Cover
Playing Music
Press the button.
Playback starts.

Connecting the USB cable

Before connecting the yepp to PC, make sure to install USB driver.
1
Connect a USB cable to the USB port on the
computer.
2
Connect the other end of a USB cable to the USB
cable connection port on the bottom of the yepp,
and press the button on the main unit.
If you disconnect the USB cable from your PC while
implementing a command or initializing during USB
driver installation, your PC may not function correctly.
3
USB driver is installed with a message saying that
it is searching for a new device. You may not see
the display screen during installation.
Go to the device manager to check that
installation has been successfully completed.
4
Upon installation of the USB driver
"SAMSUNG YP-T5" will appear in the
[Start] [Settings] [Control Panel]
[System Properties] [Device Manager].
2