How To Use - Swann Dirt Master SC17310N Manual

3. Don't use water above 40 degrees Centigrade.
Replace cap.
4. Place bottom of clean water tank into carpet
washer and push back until it locks into place.
Usage
Plug cord into electrical outlet. Turn on the ma-
chine by using on/off switch located on the side of
the machine.
1. Step onto the handle release pedal to put the
machine into cleaning position (fig 6/1). While
depressing the solution spray trigger, pull carpet
washer in a backward motion. Release the trigger
and push the unit forward in the same path to agi-
tate and remove the dirty water and solution from
the carpet. Repeat on more heavily soiled areas if
necessary.
SC17310N_IMindd.indd 10

HOW TO USE

IMPORTANT: for best results use a slow,
steady forward and backward motion. Always
work from back to front across the room to
avoid stepping on wet carpet.
2. When dirty water tank is full, lift the latch and
remove from base unit using the handle.
3. Twist dirty water tank outlet cap to the left and
remove, empty, rinse and replace.
10
09/07/2020 13:12