Place The Pool Cleaner In The Pool - Maytronics CLASSIC 8+ User Instructions

Position the power supply so that it is approximately at the center of the long side of the pool at
5.2.1
min 3.5m/12ft from the pool and placed min 11cm/4'' above the ground.
Attach the blue cable to the power supply by inserting it with the notch on the connector (1) lined
5.2.2
up with the groove in the socket on the power supply and turning clockwise (2).
5.2.3 Plug in the power supply and leave it in the OFF position.

5.3 Place the Pool Cleaner in the Pool

5.3.1
If your Pool Cleaner is equipped with brushes that contain sponges,
dip the brushes in the water and squeeze them so that they will
absorb water the first time you use the Pool Cleaner, or if the
brushes have dried out between uses.
5.3.2
Release the Pool Cleaner and let it sink to the floor of the pool.
5.3.3
Make sure that the blue cable is free of any obstructions.
5.3.4
To avoid kinks in the blue cable, place approximately enough cable
in the water for the Pool Cleaner to reach the farthest corner of the
pool.
5.3.5
Turn the power supply ON.
The Pool Cleaner will now operate until it has reached the end of
the cleaning cycle.
6
1
2
CLASSIC 8+ / TOP 8
User Instructions
|