Table of Contents
Advertisement
18
AL-1291 Point ID DGP
Installation Manual
6. DGP mode menu
Use this menu to select DGP address and polling modes.
1. Enter 6 and press Enter to access the DGP
mode menu (Figure 24), or if you do not
need to use this menu, press Enter to scroll
to
7. Factory defaults menu
2. Figure 25 shows the three address mode
options. To toggle between options, press the
* key. To accept the displayed mode and
scroll to the next menu option, press the #
key.
1 DGP address. Allows for a total of 16
zones (inputs) and 16 relays (outputs).
1 DGP plus expansion. Allows for a
total of 32 zones (inputs) and 16 relays
(outputs).
2 DGP addresses. Not supported, do
not use.
3. Figure 26 shows the two polling mode
options. To toggle between options, press the
* key. To accept the displayed mode and
scroll to the next menu, press the # key.
Extended mode. Polls 16 point ID
devices and has enhanced reporting
features.
Standard mode. The system does not
support this option. Do not use.
The polling mode is available for
compatibility with older products and
should be set to extended mode.
Figure 24. DGP mode menu
on page 19.
Figure 25. Address mode
Figure 26. Polling mode
6. DGP mode
0 - EXIT, Menu:
1 DGP address
* = Change, # = Enter
1 DGP plus expansion
* = Change, # = Enter
2 DGP addresses
* = Change, # = Enter
Extended mode
* = Change, # = Enter
Standard mode
* = Change, # = Enter
Advertisement
Table of Contents
