Control Window - Sensor Therm METIS M3F1 User Manual

 Data Playback
-
window (SensorTools viewer, see 7.3). To compare several measurement curves, you can select
several files, each file will be opened in a separate window.
-
the files you want to copy, the original files are not removed. In the next window a folder can be se-
lected where files should be copied. Then a file name is suggested containing date and time. All
selected files will be numbered in sequence with the chosen name.

Control Window

7.2.2
 Measuring mode F means that the
flame temperature is displayed. In
the measured temperature selection
field it can be changed to 2-color
temperature or temperature of
channel 1 or channel 2.
 The internal device temperature
(DT) depends on the ambient tem-
perature and the device self-
heating.
- M3F1 models are permissible up
to maximum 80°C.
 The status of the digital inputs / outputs is indicated by an LED symbol:
- Input (IN) or output (OUT) active
- Input (IN) or output (OUT) inactive
- Input (IN) or output (OUT) not activated (no function)
Measured temp. determines the temperature displayed at the top of this window (alternatively, flame
temperature, 2-color or 1-channel temperature).
 Adapt parameters: Parameter changes are immediately
transferred to the pyrometer.
- Device parameters
- The response time t
measurement conditions.
Selecting "Minimum" the pyrometer works with its short-
est possible response time of <1 ms. Under "User
definded" times between 1 ms and 10 s can be entered.
- Storage mode (see 6.9): switches on (and off) the peak
picker and allows clear settings for the activated peak
picker.
- Measurement parameters: The displayed measuring pa-
rameter depends on the measuring mode. In case of flame
measurements, the soot factor can be set, in case of ratio
temperature measurements, the emissivity slope can be
set (see 6.2); in the case of 1 channel measurements, the
emissivity input field is available first.
- The setting field can be extended to display the
measurement parameters for all channels.
- To display further sub-parameters, each individual
parameter can be extended
- Soot factor (see 6.1): Entering the flame's soot factor
- Emissivity sum channel (Ɛ1 +Ɛ2) (see 6.3): Adjustment of the surface properties in 1-color mode.
The sum channel takes account of the emissivity of both channels.
22
Press the "Load data" button to open a saved file and display in the playback
Press "Copy data file" to copy one or separate files into another folder. Select
Measured temperature
Temp. measuring mode
Status of the digital
inputs / outputs
Device parameters
Measurement parame-
ters (extendable)
(see 6.8) can be adapted to the
90
SensorTools Software
Device temperature
Set point temp.
(devices with PID
controller)
Measuring mode
selection
Parameter quick
adjustment
Measurement pa-
rameters quick save
Device configuration
Show measuring
parameters of all
channels
Further settings
for measuring
parameters
METIS M3F1