Pioneer SGY-PM930H User Manual page 26

EN
Pairing with the Cyclocomputer
6. Select [Add].
"Searching" appears in the sensor list.
7. Check the information about
the sensor.
"Connected" appears in the sensor list
when the sensors are found.
8. Select the sensor to be
checked.
Check the following items.
• [Status]
Make sure that "Connected" is
displayed.
• [Device Number]
Make sure that the device number
is the same as the device number
of the transmitter.
26
• The device numbers are printed on
the right junction box and on the side
of the left sensor. If the numbers
that are displayed on (Page 8)
[Device Number] are different from
the transmitter device numbers,
delete the device numbers from
the sensor list once, and then re-
select the checkboxes of the device
numbers of the sensors that you
want to connect from [Add Sensor].
• If "Searching" is displayed in the
[Status] area, the information from
the sensor is not being received
correctly because transmission
conditions are bad. Make sure
that the sensor you are pairing is
activated, then bring the SGX-CA600
closer to the sensor.
• Pairing with the sensor may not be
possible due to interference in the
same frequency band. If the sensor
does not appear in the list even if the
SGX-CA600 is moved closer to the
sensor and the sensor is added, try
again someplace where there is no
interference from microwaves, radio
waves, or wireless equipment.
Pairing of the sensor is completed.