Advertisement
Before you call for service...
Troubleshooting Tips - Save time and money! Review the charts on the following pages, or visit
GEAppliances.ca. You may not need to call for service.
Problem
Noise
Detergent left in
dispenser cups
Water standing in the
bottom of the tub
Suds in the tub
Stained dishwasher parts
Dishwasher won't run
Steam
Beeping at the end
of the cycle
12
Possible Causes
Some of the sounds you'll
hear are normal
Utensils are not secure in the
rack or something small has
dropped into the rack
Motor hums
Dishes are blocking the
detergent cups
Drain is clogged
This is normal
Correct detergent wasn't used
Rinse agent was spilled
Detergent with
colorant was used
Some tomato-based
foods can stain
Fuse is blown, or the
circuit breaker tripped
Power is turned off
Reboot your control
This is normal
This is normal
What To Do
start the dishwasher.
do not use your dishwasher often, set it to fill and pump
out once every week. This will help keep the seal moist.
of the desired cycle. Advance the control to the start of
the desired cycle.
If you have an air gap, clean it.
you may need a plumber.
bottom at the back of the tub keeps the water seal lubricated.
suds evaporate. Add 3.8 liters of cold water to the tub. Close
and latch the dishwasher. Repeat if necessary.
will discolor the tub interior with extended use. Check the
detergent cup for signs of any discoloration. If cup is
discolored, change to detergent without any colorant.
RINSE ONLY cycle after adding the dish to the
load can decrease the level of staining.
from the circuit.
wall switch, often located next to the disposer switch. Make sure it is on.
30 seconds, then turn back on.
water is being pumped out.
3
will display at the end of the wash cycle.
Hide quick links:
Advertisement
