Using The Command And Response Table; Command And Response Table For Sis Commands - Extron electronics HAE 100 4K Plus User Manual

Using the Command and Response Table

The Command and Response Table below shows SIS commands for the HAE 100 4K Plus.
Command and response examples are shown throughout the table. Symbols are used throughout
the table to represent variables in the command and response fields. Use the ASCII to HEX
Conversion Table with the Command and Response Table.
Space

Command and Response Table for SIS Commands

Command
Signal status
Input/Output Signal Status
Input HDCP Status
Output HDCP Status
Input Audio Status
EDID Minder
View EDID in HEX format
View EDID Native Rate
X! = Input audio status:
KEY:
0 = No audio detected or detected audio cannot be de-embedded
= S/PDIF Bitstream audio detected
1
X# =
= off, disabled or not detected
0
X& = 128 or 256 Byte EDID raw HEX (text form) from currently assigned EDID
X* = Native resolution and refresh rate from currently assigned EDID (Ex: 1920x1080 @60 Hz)
X1@ = Input HDCP status:
= No active video source detected
0
= Video detected without HDCP (not encrypted)
1
X1# = Output HDCP status:
= No sink detected
0
= HDCP sink detected not encrypted
2
ASCII to HEX Conversion Table
ASCII
Command
(host to unit)
E }
0 LS
E }
IHDCP
E }
OHDCP
1S
E }
REDID
E }
NEDID
1
= Non-HDCP sink detected (sink is not HDCP compliant)
1
.
Response (unit to host)
X# • X#]
X# • X#]
Sig
X1@]
X1@]
HdcpI
X1#]
X1#]
HdcpO
X!]
X!]
AudI
X&]
X*]
2 = 2-Ch LPCM detected
= on, enabled, or detected
= Video detected with HDCP (encrypted)
2
= HDCP sink detected and encrypted
3
HAE 100 4K Plus • SIS Commands
Additional Description
Input•Output
Verbose mode 2/3
Verbose mode 2/3
Verbose mode 2/3
Verbose mode 2/3
HEX data from currently assigned
EDID
Example:
1080P@60.0Hz
9