Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Garmin GTB 10
Summary of Contents for Garmin GTB 10
- Page 1 ONDECK ™ Owner’s Manual...
- Page 2 © 2020 Garmin Ltd. or its subsidiaries All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements.
- Page 3 I am not receiving alarm notifications ......... 5 I'm worried my OnDeck system might discharge my battery ..5 The GTB 10 hub does not stay in a full-power state, the OnDeck Wi‑Fi access point goes away, and my chartplotter does not automatically re-enable it ............
-
Page 5: Getting Started
On the mobile device, select Settings > Wi-Fi. • To show and hide sensors, select Edit, and select the Bring the mobile device within 32 m (105 ft.) of the GTB 10 sensor to show or hide. hub. • To rearrange the order of the sensors, select Edit, and Select the Garmin network, and enter the password. -
Page 6: Alarm Notifications
Follow the on-screen instructions to add your phone number and email address. Enable the toggle switch next to your name to receive text and email messages as needed. Adding Contacts You can add contacts to receive notifications from your OnDeck system. - Page 7 From the chartplotter, select A/V, Gauges, Controls > Switching. If necessary, select Menu > Setup to configure the switches pages. Select a switch to turn it on or off. Tracking and Security You can view the location of the vessel and enable the security features.
-
Page 8: Troubleshooting
Connected to view the sensor activity in the Sensors list and receive alarm notifications (Configuring the Security Sensor, Verify the GTB 10 hub is on and is held in a full-power state. page 2) . Using a slim object, such as an unbent paperclip, press and If you have not installed and configured the security sensor, you hold the recessed FACTORY RESET button. - Page 9 TIP: You can drag a sensor to move it. discharge my battery The OnDeck GTB 10 hub switches to running on the internal My bilge pump shows as always running battery when it is not in a full-power state and the voltage of the Verify the operation of the bilge pump.
-
Page 10: Compatible Sensors
The device automatically turns off after 30 minutes of inactivity. NMEA 2000 draw 75 mA max. If the GTB 10 hub is not connected to a chartplotter, you must Backup battery life 48 hours (typical use) change the Wi‑Fi password for security reasons and to properly register the device to your account. - Page 11 GPS speed over ground Vessel heading Vessel speed through water Wind data Fuel flow rate Engine hours Engine warning indicators NOTE: The data from NMEA 2000 sensors is not uploaded when the GTB 10 hub is running on the internal backup battery. Appendix...
- Page 12 Index activating 1 ActiveCaptain 1 alarms 2, 5 offline 3, 4 alerts 2 cellular service 1 contacts 2 data 4 diagnostics 4 factory settings 4 Garmin product support. See product support geofences 3 GPS 5 help. See product support LED 4 locating the vessel 3 location alarms 3 boundaries 3 location alarm 3 multiple vessels 5 NMEA 2000 4 notifications 2...
- Page 14 September 2020 GUID-1A1F58AA-95F0-4800-804B-4976606478EE v1...
Need help?
Do you have a question about the GTB 10 and is the answer not in the manual?
Questions and answers