Care & Maintenance - Yamaha SEASCOOTER 275L User Manual

14. Unplug the Charging Base from the electrical socket/plug.
15. Allow battery to stand for 30 minutes before using it.
16. Unplug the Battery Pod from the Charging Base.
17. When ready to use, reconnect to the unit in the correct
position. (see Fig. 17)
18. MAKE SURE the O-ring Seals and sealing surfaces are
clean and fully lubricated
with the supplied grease
EVERYTIME (you can also
buy this at your local
hardware store) before
replacing the Nose Cone.
(see Fig. 18)
19. Ensure the Vent O Ring is
fitted correctly into the
groove and fully lubricated
with the supplied grease. (see
Fig. 18)
20. MAKE SURE to screw in the
Vent Plug to seal the vent.
21. Replace the Nose Cone and
close the Latches.
Silicone
Grease
Sealing Surface
O-ring Seals
18
Fig.17
Vent O Ring
Battery Pod
Fig.18
Care and Maintenance
Battery and Catalyzer Care
Please read and understand important Battery Use safety
information on pages 12, 13, 14 and 15.
• The battery supplied with your SEASCOOTER
last about 200 cycles or two years before it should be
replaced. Please contact your local customer service
center/distributor. Using a battery in excess of these
recommendations can result in excessive off-gassing of
hazardous gases.
• If the catalyzer is wet, it will not function and must be
allowed to dry out before use.
Catalyzer
19
should
™
Fig.19