Page 2
EXPLANATION OF SYMBOLS AND SAFETY WARNINGS MODEL Blade 25.4 cm Line head 25.4 cm APPROVAL NUMBER OF CE EXHAUST EMISSION REGULATION GB-2 Husqvarna Zenoah Co., Ltd. BCZ2610DL 80100101 and up 1st January 2008 Masahiko GOUDA WARNING!!! RISK OF DAMAGING HEARING Wear head, eye and ear protection.
GB-4 (when using ZENOAH genuine oil) 4. Symbols on the machine For safe operation and maintenance, symbols are carved in relief on the machine. According to these indications, please be careful not to make a mistake.
2. Never use the product, a. when the ground is slippery or when you can’t maintain a steady posture. BCZ2610DL b. At night, at times of heavy fog, or at any other times when your field of vision might be...
Page 6
If it continues to rotate even after the throttle has been moved fully back, turn off the engine and take the unit to your authorized ZENOAH servic- ing dealer for repair. USING THE PRODUCT IMPORTANT Cut only materials recommended by the manufacturer.
Page 7
BCZ2610DL HANDLING FUEL 1. The engine of the ZENOAH prod- uct is designed to run on a mixed fuel, which contains highly flam- mable gasoline. Never store cans of fuel or refill the tank of the unit...
BCZ2610DL 6. Set up SUSPENSION POINT NOTE Be the SUSPENSION POINT in the location of the arrow mark. INSTALLING HANDLE NOTE The handle is put during the arrow mark. • Mount the handle to the shaft tube and suspension point it at a location that is comfortable to you.
• The Zenoah engines are lubricated by oil specially formulated for air-cooled 2-cycle gasoline engine use. If Zenoah oil is not available, use an anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle engine use (JASO FC GRADE OIL or ISO EGC GRADE).
BCZ2610DL 8. Operation STARTING ENGINE WARNING The cutting head will start rotating upon the engine starts. 1. Feed fuel into the fuel tank and tighten the cap se- curely. 2. Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects, as it will start rotating upon starting of the engine.
Page 11
• Replace by a suitable recommended cutting attach- ment according to the object to be cut. • When replacing blade always be sure to use products which have been certified by ZENOAH. WARNING • When sharpening, removing, or reattaching the blade, be sure to wear thick, sturdy gloves and use only proper tools and equipment to prevent injury.
Page 12
BCZ2610DL 8. Operation CUTTING METHOD (a) Use the front left side cutting. (b) Guide the blade from your right to left with it tilted slightly to your left. (c) When mowing a wide area, start working from your left end to avoid interference of cut grass.
Page 13
6. While holding the spool against the housing, pull the line ends to release them from the slot. 7. Line up the slot on the bottom cap with the hook on the housing, press the cap against the housing until it clicks. BCZ2610DL Note after after replace, if necessary...
BCZ2610DL 9. Maintenance AIR FILTER • The air filter, if clogged, will reduce the engine perfor- mance. Check and clean the filter element in warm, soapy water as required. Dry completely before in- stalling. If the element is broken or shrunk, replace with a new one.
Store the unit indoor taking necessary measures for rust prevention. 11. Disposal When disposing your machine, fuel or oil for the machine, be sure to allow your local regulations. Cylinder BCZ2610DL GB-15...
(exhaust port) → carbon is built-up air cleaner cylinder fin, fan cover When your unit seems to need further service, please consult with our ZENOAH service shop in your area. Limited warranty Should any failure occur on the product under normal oper-...