Page 1
WARNING Before using our products, please read this manual carefully to understand the proper use of your unit. BM40S WARNING This sprayer is not designed to be used with acids of any kind, corrosive products like caustic soda, gasoline, materials capable of generating heat, hot fluids, explosive or highly volatile products.
Instructions contained in warnings within this manual and warning seals marked with a symbol on the sprayer concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail. Note that there may be times when warning seals peel off or become soiled and impossible to read.
1. Parts location Tank shape is a Trademark of SP Systems LC /Swissmex 2. Specifications Type········································································Back Pack Model Name ·································································BM40S Dimensions (LxWxH) ·························530x360x210 (20.9x14.2x8.3) mm (in) Dry Weight··········································································5.2 (10.4) kg (lbs) Tank Capacity·································································15.1 (4.0) litter (Gal) Max. Pressure ····························································10.5 (150) kgf/cm Working Pressure········································1.05 –...
Page 4
4. For safe operation 5. Wear sturdy rubber-soled shoes or shoes with some other form of anti-slip protection to help protect you against falling when filling, using and/or cleaning the sprayer. 6. Do not wear loose clothing, scarves, neck chains, hair longer than shoulder length, and the like when filling, using and/or cleaning the sprayer.
4. For safe operation • Make sure the spray hose loops freely without kinking or squeezing. 4. After using sprayers and other equipment, CLEAN UP! Dispose of debris in trash receptacles. ■ MAINTENANCE 1. In order to maintain your product in proper working order, perform the maintenance and checking operations described in the manual at regular intervals.
6. Pre-operation NOTE Hose clamps are not completely tight. Please tighten hose clamps prior to using. Hose clamps are left loose to extend life of gaskets and fittings. WARNING Oil cap gasket before using and lubricate weekly so the gasket will seal properly and prevent chemical leaks. Oil check valve and maintain breather hole clear of debris.
8. Maintenance WARNING Before you remove cap, be sure there is no pressure in the tank. in order to release pressure, invert unit upside down and squeeze spray pistol (aim away from you). Pressure will escape; when hissing stops, all pressure has been released.
11. Parts list NOTE : 1. Use RedMax/ZENOAH genuine parts as specified in the parts list for repair and/or replacement. 2. RedMax/ZENOAH does not warrant the machines, which have been damaged by the use of any parts other than those specified by the company.
Page 11
11. Parts List : BM40S Key# Part KIT Number RMKIT01AS Tank strainer. RMKIT527 Red tank Lid with integrated handle, duck valve & seal. RMKIT528 • Duck valve for Lid. RMKIT02A • Seal for cap 6". RMKIT04 Nylon bearings. RMKIT05 Pump lever set.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE. IF YOU NEED TO OBTAIN INFORMATION ABOUT THE NEAREST SERVICE CENTER, PLEASE CALL RedMax / ZENOAH AMERICA, INC. AT (770)-381-5147.
Need help?
Do you have a question about the BM40S and is the answer not in the manual?
Questions and answers