NOTE: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used with the unit to insure compliance. Changes or modifications to this unit not expressly approved by Zebra Technologies Cor- poration could void the user’s authority to operate this equipment.
Page 4
No Liability for Consequential Damage In no event shall Zebra Technologies Corporation or anyone else involved in the creation, production, or delivery of the accompanying product (including hardware and software) be liable for any damages whatsoever (including, without limitation, damages for loss of...
Page 5
The copyrights in this manual and the label print engine described therein are owned by Zebra Technologies Corporation. Unauthorized reproduction of this manual or the software in the label print engine may result in imprisonment of up to one year and fines of up to $10,000 (17 U.S.C.506).
Page 6
This user’s guide gives you the information you will need to operate the EM 220 series printer. For a list of supplemental manuals provided with the EM 220, please refer to the Manual Information section.
This user’s manual contains basic information for product usage as well as for emergency measures that may be required when using the EM 220 printer. ※ For additional information on the EM 220, please refer to the following supplemental manuals: 1.
EM 220 ■ Safety Precautions When using the EM 220 printer, please follow the recommended safety regulations provided below. Warning Violating the following instructions may cause serious injury. 1. Do not plug several products in one multi-outlet; this can provoke over-heating and a fire.
Page 9
• Turn off the printer and unplug the unit from the electrical outlet. • Contact an authorized Zebra Technologies service provider for repair. 2. Keep the packet of desiccant material (silica gel) out of children’s reach. 3. Use only approved accessories for your printer; do not disassemble or attempt to repair the printer yourself.
Page 10
Rev. 1.00 Charging under conditions not included in such This will cause reverse - 10 - Mobile Printer User’s Manual EM 220...
Page 11
7. If the battery is leaking electrolytic solution and the solution enters the eyes, immediately rinse the eye with clean water, and then consult a physician. Neglecting to do so may cause permanent eye injuries. Rev. 1.00 Allowing battery terminals to contact - 11 - Mobile Printer User’s Manual EM 220...
Page 12
5. If upon first use following purchase, a strange odor, overheating, and/or anything deemed out of the ordinary is detected, discontinue use and contact an authorized Zebra Technologies service provider. 6. Store the battery in a location that is out of the reach of small children. During usage, make sure to place the charger and/or product out of the reach of small children.
Page 13
9. Each battery has a product life. If the usage time of the product has become short, replace the battery. Wrap the terminals of used batteries with tape to insulate prior to disposal. Rev. 1.00 High humidity may cause - 13 - Mobile Printer User’s Manual EM 220...
EM 220 1. Content Confirmation Contact the dealer from which the purchase was made if any item is damaged and/or missing. EM 220 Battery Battery Charger Power Cord Belt Strap Cleaning Pen Paper User Manual ※ Optional items Battery Holder...
• Front Power Button Paper Feed Button MSR Cover • Rear Belt Strap Hole Interface Cap Cable Connection Rev. 1.00 Paper Cover BT Cap (Bluetooth Download Connector) Power Connection - 15 - EM 220 Open Button Battery Mobile Printer User’s Manual...
3) Plug the power cord outlet. ③ 4) Insert the battery holder ③ heard. - 16 - EM 220 to the battery ② ① to the ① into an electrical ② into the battery ④...
LED turns on for two seconds. CAUTION If the red LED turns on for two seconds, it may indicate a battery-charging problem. Please consult the reseller. WARNING Use only designated AC/DC adaptor. (12VDC, 5A) - 17 - Mobile Printer User’s Manual EM 220...
Page 18
Batteries are charged to 8.4VDC, 0.8A 4) Push the hook and pull up to extract the battery. Charge Status Charging Charging Complete Problem with Battery and/or Placement - 18 - Mobile Printer User’s Manual EM 220 Charge Time 2 hours...
3) Ensure that you align the paper correctly. 4) Pull the paper out as shown in the image and close the paper cover. 5) Tear off any excess paper in the direction of the side of the printer. - 19 - Mobile Printer User’s Manual EM 220...
2) Use a coin to tighten the belt strap screw as shown in the image. 3) Undo the belt strap Velcro. 4) Fasten the belt strap to a belt. 5) Close the Velcro as shown in the image. - 20 - Mobile Printer User’s Manual EM 220...
4) Affix to a belt using the clip at the rear of the case. Belt NOTE The clip on the leather case can be rotated three stages by 30° per stage (maximum 90°) - 21 - EM 220 Mobile Printer User’s Manual...
2) If only the green LED is lit, the printer has entered the power saving mode. NOTE The power saving mode is activated after the first communication, with the default time interval being 10 seconds. Rev. 1.00 - 22 - Mobile Printer User’s Manual EM 220...
If the card does not register, first check to see if it is properly aligned. When swiping the card, the recommended swiping speed is 100 ~ 1500 mm/sec. This function is independent of such other devices and - 23 - EM 220 Mobile Printer User’s Manual...
3) After the following printout is outputted, press the power button to perform auto calibration. Select the mode Auto Calibration: Power Button Self Test: Feed Button 4) Three pages of label paper are outputted when performing auto calibration. Rev. 1.00 - 25 - Mobile Printer User’s Manual EM 220...
(PDAs, PCs, etc.). NOTE The interface cable that can be connected with the printer is available in both USB and Serial type. Refer to the service manual for detailed interface cable specifications. - 26 - Mobile Printer User’s Manual EM 220...
3) Use a cloth moistened with an alcohol solution to clean the paper sensor and remove any paper remnants and/or dust. 4) Insert paper into the printer 1~2 minutes after completing the cleaning process and close the printer cover. Rev. 1.00 - 27 - Mobile Printer User’s Manual EM 220...
The label types used with this printer is as follows. • Rating Labels: PP • Other Labels: PET Rev. 1.00 EN55002 Class B:1998+A1:2000 EN55024:1998+A1:2001 EN61000-3-2:2000 EN61000-3-3:1995+A1:2001 EN6100-4-2:1995+A1:1998+A2:2001 EN6100-4-3:1996+A1:1998+A2:2001 EN6100-4-4:1995+A1:2001 EN6100-4-5:1995+A1:2001 EN6100-4-6:1996+A1:2001 EN6100-4-8:1993+A1:2001 EN6100-4-11:1994+A1:2001 EN310489-17 v1.2.1 EN300328 v1.6.1 Safety: EN60950-1:2001 - 29 - Mobile Printer User’s Manual EM 220...
Page 30
______________________________________________________________________ Zebra Technologies International, LLC 333 Corporate Woods Parkway Vernon Hills, Illinois 60061, 3109 USA Phone: +1.847.634.6700 Toll-Free: +1.800.423.0422 Fax: +1.847.913.8766...