Cleaning; Cleaning The Blender - Silvercrest SSM 600 B2 Operating Instructions Manual

Cleaning

DANGER! ELECTRIC SHOCK!
Before starting to clean the blender and its components:
► Ensure that the motor is switched off and the power plug removed from the
socket.
Do not immerse the motor block 6 in water or other liquids. This could
result in you receiving a fatal electric shock and cause damage to the
appliance.
► Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
Never disassemble the cutting blades 4 and never reach into the blender 3.
►
The cutting blades 4 are extremely sharp!
CAUTION! PROPERTY DAMAGE!
► Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.

Cleaning the blender

To prevent injuring yourself on the cutting blades 4, clean the blender 3 only
■
with a long-handled washing-up brush.
Clean the measuring cap 1 and the lid 2 in mild soap solution. Ensure that
■
the rubber seal 9 is correctly fitted before using the lid 2 again.
NOTE
■ If you clean the blender directly after use, you can often achieve a
satisfactory and hygienic level of cleaning by doing the following:
Fill the blender 3 with 750 ml of water and add a few drops of mild
detergent. Close the lid 2 and fit the blender 3 onto the motor block 6.
Insert the plug into a mains power socket and activate the Ice Crush/Clean
operation a few times, so that the cutting blades 4 churn through the water
at full speed.
Afterwards, rinse out the blender 3 with lots of clean water to ensure that
all detergent residues have been removed.
SSM 600 B2
You can also clean the lid 2, the measuring cap 1 and the
blender 3 with the cutting blade 4 in your dishwasher.
GB │ IE │
31 ■