Service And Spare Parts; Something Not Working - Zanussi WDA 1055 W Instruction Booklet

Symptom
The door will not open
Spinning starts late or the machine
does not spin
The machine makes an unusual
noise
No water is visible in the drum
The machine does not dry or does
not dry properly
Service & Spare Parts
In the event of your appliance requiring service, or if
you wish to purchase spare parts, please contact your
local Zanussi Service Force Centre by telephoning:
0870 5 929929
Your telephone call will be automatically routed to the
Service Force Centre covering your post code area.
The addresses are listed on the following pages.
Before calling out an engineer, please ensure you have
read the details under the heading "Something Not
Working".
When you contact the Service Force Centre you will
need to give the following details:
1. Your name, address and post code
2. Your telephone number
3. Clear and concise details of fault
4. The model and serial number of the appliance (found
on the rating plate - see picture).
5. The purchase date
Possible causes
I
The programme is still running.
I
The door lock has not yet released.
I
Water in the tub: the door cannot be opened if water is present in the
tub.
I
The electronic unbalance detection device has cut in because the
laundry is not evenly distributed in the drum. The laundry is
redistributed by reverse rotation of the drum. This may happen several
times before the unbalance disappears and normal spinning can resume.
If, after 10 minutes, the laundry is still not evenly distributed in the
drum, the machine will not spin. In this case, redistribute the load
manually and reselect the spin programme.
I The machine is fitted with a type of motor which makes an unusual
noise compared with other traditional motors. This new motor ensures
a softer start and more even distribution of the laundry in the drum
when spinning, as well as increased stability of the machine.
I
Machines based on modern technology operate very economically
using very little water without affecting performance.
I
The drying time has not been selected
I The water taps are not turned on
I The drain filter is clogged
I
The machine is overloaded
I
The selected drying time/section is not suitable for the laundry
Customer Care
For general enquiries concerning your Zanussi appliance
or for further information on Zanussi products, please
contact our Customer Care Department by letter or
telephone as follows:
Customer Care Department
Zanussi
55-77 High Street
Slough
Berkshire
SL1 1DZ
Tel 08705 727727*
or visit our website at www.zanussi.co.uk
* calls to this number may be recorded for training
purposes.
22