Installation Instruction - Zanussi ZWG 5120 User Manual

Installation instruction

Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever
has to be transported again.
1. After removing all the packaging, carefully
lay machine on it's back to remove the
polystyrene base from the bottom.
2. Remove the power supply cable and the
draining hose from the hose holders on the
rear of the appliance.
3. With a suitable spanner unscrew and
remove the central rear bolt A.
4. Unscrew and remove the two large rear
bolts B and the six smaller bolts C.
D
24
5. Remove the bracket D, refit the six smaller
6. Open the porthole, take out the inlet hose
7. Fill the smaller upper hole and the two large
Positioning
Install the machine on a flat hard floor. Make
C
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
B
B
the machine does not touch the wall or other
C
kitchen units. Level the washing machine by
raising or lowering the feet. The feet may be
tight to adjust as they incorporate a self locking
nut, but the machine MUST be level and
stable.
Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and
displacement of the machine during
operation.Never place cardboard, wood or
similar materials under the machine to
compensate for any unevenness in the floor.
bolts C and slide out the relevant plastic
spacer E.
from the drum and remove the polystyrene
block fitted with the adhesive tape on the
door seal.Open the porthole, take out the
inlet hose from the drum and remove the
polystyrene block fitted with the adhesive
tape on the door seal.
ones with the corresponding plastic plug
caps supplied in the bag containing the
instruction booklet.