Advertisement
Walk Behind String Trimmer
OPERATOR'S MANUAL
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL
BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
Warning: The Engine Exhaust from this product contains chemicals known to
the State of California to cause cancer, birth defects or other reproductive harm.
www.support@pulsar-products.com
M
o
e d
:# l
PTG1022H
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Pulsar PTG1022H
- Page 1 :# l PTG1022H Walk Behind String Trimmer OPERATOR’S MANUAL WARNING READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. Warning: The Engine Exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
-
Page 2: Table Of Contents
To The Owner Thank You Thank you for purchasing this Pulsar String Trimmer. It was carefully engineered to provide excellent performance when and equipment without notice and without incurring obligation. properly operated and maintained. If you have any problems or questions concerning the machine, Please read this entire manual prior to operating the equipment. -
Page 3: Important Safe Operation Practices
Important Safe Operation Practices WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. - Page 4 Do not put hands or feet near or under rotating parts. Keep Muffler and engine become hot and can cause a burn. Do clear of discharge area at all times as the rotating spindle not touch. and trimmer lines can cause injury. Only use parts and accessories made for this machine by Never operate the string trimmer without proper shields, the manufacturer.
- Page 5 Use extreme care when approaching blind corners, Before cleaning, repairing, or inspecting, make certain the doorways, shrubs, trees, or other objects that may obscure spindle and all moving parts have stopped. Disconnect the your vision of a child who may run into the string trimmer. spark plug wire and ground against the engine to prevent unintended starting.
- Page 6 Safety Symbols This page depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbol Description READ THE OPERATOR’S MANUAL(S) Read, understand, and follow all instructions in the manual(s) before attempting to assemble and operate EYE PROTECTION Always wear safety glasses or safety goggles when operating this machine.
- Page 7 2 — i ection mportant peration racticeS...
-
Page 8: Assembly & Set-Up
Assembly & Set-Up Contents of Carton • One String Trimmer • One Pack of Trimmer Line • One String Trimmer Operator’s Manual Assembly Upper Handle NOTE: This string trimmer is shipped without gasoline or oil Remove the triangle knob and carriage bolt from the in the engine. - Page 9 Starter Rope Set-Up Disconnected the spark plug boot from the spark plug. Gas and Oil Fill-Up Pivot the control handle against the upper handle and pull the rope out of the engine. Add oil provided before starting unit for the first time out Put the starter rope into the hook.
-
Page 10: Controls & Features
Controls and Features Control Lever Recoil Starter Flywheel Screen Trimmer Line Trimmer Shield Spindle Figure 4-6 Recoil Starter Spindle The recoil starter is attached to the right side of the upper The spindle rotates the trimmer line. handle. Stand behind the unit and pull the recoil starter rope to Trimmer Line start the unit. -
Page 11: Operation
Operation Adjusting the Spindle Height The spindle height can be adjusted for various applications. To do so, proceed as follows: Loosen the bolt found on side of the spindle shaft. • The string trimmer is designed with the spindle offset to the left side, allowing the operator to trim along a fence, Note: The bolts are designed so that they cannot be landscaping, or a house to his or her’s right side without... -
Page 12: Maintenance & Adjustments
Maintenance & Adjustments Maintenance Deck Care Clean underside of the machine after each use to prevent build- General Recommendations up of grass clippings or other debris. Follow steps below:. • Always observe safety rules when performing any Disconnect spark plug wire. Drain gasoline from string maintenance. -
Page 13: Troubleshooting
Troubleshooting Problem Cause Remedy Engine Fails to start 1. Control lever disengaged. 1. Engage control lever. 2. Spark plug boot disconnected. 2. Connect wire to spark boot. 3. Fuel tank empty or stale fuel. 3. Fill tank with clean, fresh gasoline. 4. -
Page 14: Warranty
Pulsar Products Inc. authorized service dealer, is found to be detective within the original warranty period. Pulsar Products Inc. will also decide upon the use of new or rebuilt parts or comparable product. Any part or product that is replaced will be retained by Pulsar Products Inc. - Page 15 Take the original receipt and product to the place of purchase or mail the original receipt and product to the address found on the web site if purchased on-line. You can also locate your nearest Pulsar Products Inc. dealer for service or warranty questions by calling toll free at 1-866-591-8921.Pulsar Products Inc.
Need help?
Do you have a question about the PTG1022H and is the answer not in the manual?
Questions and answers
Pulley not turning spindle
Nearest authorized dealer near Mena, Arkansas or Broken Bow, Oklahoma The spindle holder vibrates. Also need a spindle head piece. Cap has fallen off.