Siemens FIDAMAT 5E Instruction Manual page 47

* 1 Change measuring range
2 Display measuring range
* 5 Calibrate zero
6 Display sensitivity setpoint
* 7 Adjust sensitivity setpoint
* 8 Calibrate senstitivity to setpoint
9 Display limits
** 11 Define start-of-scale values of measuring ranges
** 12 Define full-scale values of measuring ranges
** 13 Set time constant T
** 14 Set dynamic time constant T
15 Display compensated background current (zero calibration)
* 17 Switch over from total calibration to individual calibration
** 18 Set limits to upward or downward exceeding
** 19 Set limit
** 20 Autoranging on/off
** 21 Measured-value memory on/off
** 22 "autocal" on/off
** 23 Limit monitoring on/off
** 24 Set current output
* 29 Measure during warming-up phase
** 30 Display, enter actual temperature and setpoint temperature of oven
** 31 Display, enter actual temperature and setpoint temperature of pump
** 32 Display, enter actual temperature and setpoint temperature of heated line
** 33 Display, enter actual temperature and setpoint temperature of sample gas probe
90
(dynamic noise rejection)
D
A-11
A
A
B
B
B
B
D
G
G
E
E
I
B
D
D
A
F
C
D
F
L
D
D
D
D